Continuous Production of N–F-Codoped Titanium Oxide Photocatalyst Powders via Drip Pyrolysis in a Fluidized Bed under Reduction Conditions
スポンサーリンク
概要
- 論文の詳細を見る
This study investigates drip pyrolysis in a fluidized bed (DPFB) applied to the continuous production of anatase-type N–F-codoped titanium oxide photocatalysts with oxygen vacancy under a reducing atmosphere for the development of a more compact reactor with fewer operating steps. The effects of bed temperature, precursor sol concentration and superficial gas velocity on the particle properties of the product powder and the photocatalytic activity of gaseous acetaldehyde degradation have been investigated. Although the photocatalysts produced by DPFB showed very small N-doping as compared to F-doping, they showed higher absorbance in both visible and ultraviolet regions than those by an electric furnace (EF). The surface atomic ratio of F to Ti increased with increasing the precursor sol concentration and superficial gas velocity. The BET surface area of product photocatalyst sample prepared at 773 K by DPFB was three times larger than that by an electric furnace, and its photocatalytic activity was higher than any other photocatalysts prepared in this study.
著者
-
Kai Takami
Department Of Applied Chemistry And Chemical Engineering Kagoshima University
-
Nakazato Tsutomu
Department Of Applied Chemistry And Chemical Engineering Kagoshima University
-
Oki Satoshi
Department of Chemical Engineering, Kagoshima University
-
Shimobori Ryusuke
Department of Chemical Engineering, Kagoshima University
関連論文
- Application of Fast X-ray CT Scanner to Visualization of Bubbles in Fluidized Bed
- Dynamic Evaluation of Membrane-Electrode Assembly in Operation of a Direct Methanol Fuel Cell by Simultaneous Measurements of Crossovers of Methanol and CO_2
- Preparation of Highly Active Methanol Steam Reforming Catalysts from Glassy Cu-Zr Alloys with Small Amount of Noble Metals
- Hydrogenation of Benzene over Catalyst Prepared from Amorphous Pt-Zr Alloy
- Semi-dry Process for Production of Very Fine Calcium Carbonate Powder by a Powder-Particle Spouted Bed
- Total Solid Entrainment Rate in a Circulating Powder-Particle Fluidized Bed
- Entrainment Rates and Elutriation Rate Constants of Bed Particles and Group C Fine Powder in a Fluidized Bed and in a Circulating Fluidized Bed
- Optimization of Reaction Conditions of Two-Step Batch Operation for Biodiesel Fuel Production Using KOH Catalyst
- MEASUREMENT AND PREDICTION OF THE SURFACE TENSION OF NITROGEN + OXYGEN AND NITROGEN + OXYGEN + ARGON SYSTEM
- Penetration of fine cohesive powders through a powder-particle fluidized bed
- Methanol Diffusion through a Porous Plate in Anode Backing of a Passive Direct Methanol Fuel Cell under Closed Circuit Conditions
- Elimination of Defluidization Caused by Reactions Involving a Volume Reduction in a Fluidized Catalyst Bed and Improvement of Fluidization by Two-Stage Feeding
- Relationship between Apparent Bed Viscosity and Fluidization Quality in a Fluidized Bed with Fine Particles
- Continuous Production of N–F-Codoped Titanium Oxide Photocatalyst Powders via Drip Pyrolysis in a Fluidized Bed under Reduction Conditions
- Effect of internal baffles on conversion of hydrogen chloride oxidation and pressure fluctuations in a fluidized catalyst bed.
- Moisture Absorption Characteristics of Porous Calcium Oxide Powders Produced by Calcination of Pulverized Limestone with Inorganic Salts Using a Powder-Particle Fluidized Bed
- Continuous production of hydroxyapatite powder by drip pyrolysis in a fluidized bed
- Effects of Increase in Gas Volume on the Fluidization Properties in Fluidized Bed Reactors
- Methanation of carbon monoxide by a fluidized catalyst bed.