Transient Turbulent Heat Transfer for Heating of Water in a Short Vertical Tube
スポンサーリンク
概要
- 論文の詳細を見る
The transient turbulent heat transfer coefficients in a short vertical Platinum test tube were systematically measured for the flow velocities (u=4.0 to 13.6 m/s), the inlet liquid temperatures (Tin=296.93 to 304.81 K), the inlet pressures (Pin=794.39 to 858.27 kPa) and the increasing heat inputs (Q0 exp(t/τ), exponential periods, τ, of 18.6 ms to 25.7 s) by an experimental water loop comprised of a multistage canned-type circulation pump with high pump head. The Platinum test tubes of test tube inner diameters (d=3 and 6 mm), heated lengths (L=66.5 and 69.6 mm), effective lengths (Leff=56.7 and 59.2 mm), ratios of heated length to inner diameter (L/d=22.16 and 11.6), ratios of effective length to inner diameter (Leff/d=18.9 and 9.87) and wall thickness (δ=0.5 and 0.4 mm) with average surface roughness (Ra=0.40 and 0.45 µm) were used in this work. The surface heat fluxes between the two potential taps were given the difference between the heat generation rate per unit surface area and the rate of change of energy storage in the test tube obtained from the faired average temperature versus time curve. The heater inner surface temperature between the two potential taps was also obtained by solving the unsteady heat conduction equation in the test tube under the conditions of measured average temperature and heat generation rate per unit surface area of the test tube. The transient turbulent heat transfer data for Platinum test tubes were compared with the values calculated by authors’ correlation for the steady state turbulent heat transfer. The influence of inner diameter (d), ratio of effective length to inner diameter (Leff/d), flow velocity (u) and exponential period (τ) on the transient turbulent heat transfer is investigated into details and the widely and precisely predictable correlation of the transient turbulent heat transfer for heating of water in a short vertical tube is given based on the experimental data and authors’ studies for the transient critical heat fluxes (CHFs) of subcooled water flow boiling in a short vertical tube caused by exponentially, ramp-wise and stepwise increasing heat inputs. The correlation can describe the transient turbulent heat transfer coefficients obtained in this work for the wide range of the temperature difference between heater inner surface temperature and average bulk liquid temperature, ΔTL, of 10 to 160 K with d=3 to 6 mm, Leff/d=9.87 to 18.9, u=4.0 to 13.6 m/s and τ=18.6 ms to 25.7 s within ±15 % difference.
著者
-
MASUZAKI Suguru
National Insitute for Fusion Science
-
Hata Koichi
Institute Of Advanced Energy Kyoto University
-
Shirai Yasuyuki
Dept. Of Energy Science And Technology Kyoto University
-
KAI Naoto
Dept. of Energy Science and Technology, Kyoto Univ.
関連論文
- Abrupt Flushing of High-Density Core in Internal Diffusion Barrier Plasmas and its Suppression by Plasma Shape Control in LHD
- Achievement of 10 keV Central Electron Temperatures by ECH in LHD
- Suppression of Carbon Dust Formation by Nitrogen Injection into Hydrogen Plasmas in Detached Plasma Conditions
- Influence of Heating Rate on Subcooled Flow Boiling Critical Heat Flux in a Short Vertical Tube(International Conferences on Power and Energy)
- Critical Heat Fluxes of Subcooled Water Flow Boiling against Inlet Subcooling in Short Vertical Tube(International Conferences on Power and Energy System)
- ICONE11-36118 THERMAL ANALYSIS ON MONO-BLOCK TYPE DIVERTOR BASED ON SUBCOOLED FLOW BOILING CRITICAL HEAT FLUX DATA AGAINST INLET SUBCOOLING IN SHORT VERTICAL TUBE
- Extension of Improved Particle and Energy Confinement Regime in the Core of LHD Plasma
- Impurity Deposition and Retention of Discharge Gas on Plasma Facing Wall in LHD
- Impurity Retention Effect in the Edge Ergodic Layer of the Large Helical Device
- Helium Retention of 316L Stainless Steel Used for The First Wall of The Large Helical Device (LHD)
- Compact and Powerful Plasma Generator
- Chemical Erosion of Diamond-Coated Graphite under Low-Energy Hydrogen Atom Irradiation
- ICONE11-36116 CRITICAL HEAT FLUXES OF SUBCOOLED WATER FLOW BOILING AGAINST INLET SUBCOOLING IN SHORT VERTICAL TUBE
- A Model Generation Theorem Prover Handling Finite Interval Constraints
- Axial Profile of Balmer-Alpha Emission near a Tungsten Target in the Compact PWI Simulator APSEDAS
- Heat Transfer from a Flat Plate at One End of a Rectangular Duct Containing Pressurized He II(2) Transient Heat Transfer Caused by stepwise heat input
- Heat Transfer from a Flat Plate at One End of a Rectangular Duct Containing Pressurized He II(1) Steady-State Critical Heat Flux
- Progress in Impurity-Related Physics Experiments in LHD
- Neutral Gas Compression in the Helical Divertor with a Baffle Structure in the LHD Heliotron
- Transient Turbulent Heat Transfer for Heating of Water in a Short Vertical Tube
- Discriminating Acquisition of 15-MeV Protons from D-3He Fusion Reaction in LHD
- Microscopic Deformation of Tungsten Surfaces by High Energy and High Flux Helium/Hydrogen Particle Bombardment with Short Pulses
- Neutral Particle Transport Simulation around a V-Shaped Target Using DEGAS 2 Code
- Simulation Analysis of the Design of a Vacuum Pumping System for the Closed Helical Divertor in the Large Helical Device
- Effect of Radiation Power Loss due to Impurity Gas Puff on Divertor Plasma
- Computational Study of Turbulent Heat Transfer for Heating of Water in a Vertical Circular Tube : —Influence of Tube Inner Diameter on Thickness of Conductive Sub-Layer—
- Characterization of Ion Cyclotron Wall Conditioning Using Material Probes in LHD
- Carbon Erosion and Dust Formation under Heavy Atomic Hydrogen Irradiation
- Assessment of Plasma Performance in a Magnetic Configuration with Reduced Poloidal Coils for a Helical DEMO Reactor FFHR-d1
- Toroidal Distributions of Amounts of Retained Gases and Deposited Impurities during 13th Experimental Campaign in the LHD
- Thermionic Energy Converter System Using Heat Flux in Divertor Region
- Density Regimes of Complete Detachment and Serpens Mode in LHD
- Investigation of Carbon Films on Material Probes in the Vicinity of Local Island Divertor in the Large Helical Device
- Pellet Injection and Internal Diffusion Barrier Formation in Large Helical Device
- Characteristics of Radiating Collapse at the Density Limit in the Large Helical Device
- Heat- and Particle-Deposition Distribution on Helical Divertor Plates in LHD During Real-Time Magnetic-Axis Swing Operations
- Scaling Laws of Intermittent Plasma Turbulence in Edge of Fusion Devices
- Flux Control of Carbon Nanoparticles Generated due to Interactions between Hydrogen Plasmas and Graphite Using DC-Biased Substrates
- A Simple Method of H/He Influx Ratio Measurement as a Monitor for Machine Operation in LHD
- Thermal Analysis on Mono-Block Type Divertor Based on Subcooled Flow Boiling Critical Heat Flux Data against Inlet Subcooling in Short Vertical Tube
- Influence of Test Tube Material on Subcooled Flow Boiling Critical Heat Flux in Short Vertical Tube
- Observation of Striation in Collapsing Plasma
- Blob/Hole Generation in the Divertor Leg of the Large Helical Device
- Flux Control of Carbon Nanoparticles Generated due to Interactions between Hydrogen Plasmas and Graphite Using DC-Biased Substrates (Special Issue : Advanced Plasma Science and Its Applications for Nitrides and Nanomaterials)
- Study of a Closed Divertor Configuration for the Three-Dimensionally Complicated Magnetic Structure in the LHD Plasma Periphery