Thermal hydraulic analysis by skew upwind finite element method.
スポンサーリンク
概要
- 論文の詳細を見る
In multi-dimensional thermal hydraulic analysis, when flow is oblique to computational grid lines, false or numerical diffusion is generated by the upwind difference scheme which is almost essential at high-Peclet-number flow. This diffusion causes a large computational error, especially in the pure upwind difference scheme; therefore, some measures have been devised to improve the finite difference method. Also in the finite element method, the Streamline Upwind/Petrov-Galerkin method, and equivalent to this, the Balancing Dissipation method have been used to remedy the above problem. In this paper, however, it is shown that these finite element methods often provide numerical solutions with over- and undershoot or with spatial oscillation, which are caused by indirect 'upwinding'. As a replacement of these methods, a straightforward 'upwinding' in the finite element method is introduced in this study. The present method provides numerical solutions without causing the above problem, and is applicable to a wide range of the Peclet number.
- 一般社団法人 日本原子力学会の論文
著者
-
Ishiguro Ryoji
Department Of Nuclear Engineering Faculty Of Engineering Hokkaido University
-
ARASEKI Hideo
Department of Nuclear Engineering, Faculty of Engineering, Hokkaido University
関連論文
- Flow Induced by Temperature Gradient along Wall in Rarefied Gas Container
- Microscopic Study of CaCO_3 Scaling on Heat Transfer Surfaces
- Vapor Molecule Behavior in the Vicinity of Metal Condensation Interface
- Comparison of sodium evaporations measured under condition of fog formation.
- Sodium evaporation into a forced argon flow. II. Comparison between experimental results and theoretical predictions by critical supersaturation model.:Comparison between Experimental Results and Theoretical Predictions by Critical Supersaturation Model
- Sodium Evaporation into a Forced Argon Flow, (I):Measurements of Evaporation under Condition of Fog Formation
- Application of Galerkin finite element method to subchannel analysis, (II) Unsteady-state two-phase flow.:Unsteady-State Two-Phase Flow
- Thermal hydraulic analysis by skew upwind finite element method.
- Application of Galerkin finite element method to subchannel analysis.