The Onset of Cavitation and the Acoustic Noise Characteristics of Sodium Flow in a Venturi
スポンサーリンク
概要
- 論文の詳細を見る
The present paper described the onset cavitation conditions, acoustic noise characteristics and void behaviors of flowing liquid sodium in the venturi made of 316 SS with an inner diameter of 6.5 mm and a length of 20 mm. An experiment was conducted in the range of sodium stagnant pressure in the expansion tank of 0.061-0.181 MPa-a and in the temperature range of 200°-400°C. As a result, it was found that the noise intensity increased greatly when the cavitation coefficient approached unity (onset of cavitation), and it became saturated in lower cavitation coefficient (developed cavitation). The cavitation coefficient at the onset of cavitation was nearly equal to unity. However, an increase in temperature shifted the cavitation coefficient to a value a little higher than unity. The results also showed that velocity in the venturi at the onset of cavitation also increased by increasing the stagnant pressure. Cavitation occurrence produced a noise in the range of 600-20,480 Hz. In developed cavitation condition, the noise intensity was nearly constant at around -50 dB which might be caused by the choking of the fluid. At 400°C, instabilities or fluctuations of the noise spectrums were observed. Simulated results by using CFD showed that voids were formed at the throat of the venturi and the void fraction increased as the static pressure decreased by the flow. The voids were conveyed and collapsed in the downstream of the venturi outlet because of an increase in the static pressure. These voids could cause choking and noise as well as erosion.
著者
-
ARDIANSYAH Teddy
Department of Nuclear Engineering, Tokyo Institute of Technology
-
TAKAHASHI Minoru
Research Laboratory for Nuclear Reactors, Tokyo Institute of Technology
-
YOSHIZAWA Yoshio
Research Laboratory for Nuclear Reactors, Tokyo Institute of Technology
-
NAKAGAWA Masamichi
Department of Mechanical Engineering and Science, Tokyo Institute of Technology
-
MIURA Kuniaki
Sukegawa Electric Co., Ltd.
-
ASABA Makoto
Sukegawa Electric Co., Ltd.
-
Miura Kuniaki
Sukegawa Electric Co. Ltd.
-
Yoshizawa Yoshio
Research Associate
-
Takahashi Minoru
Research Laboratory For Nuclear Reactors Tokyo Institute Of Technology
-
NAKAGAWA Masamichi
Department of Human-Robotics, Saitama Institute of Technology
関連論文
- Prediction of Impact Shock Vibrations at Tennis Players Wrist Joint: Comparison between Conventional Weight Racket and Light Weight Racket with Super Large Head Size
- The Onset of Cavitation and the Acoustic Noise Characteristics of Sodium Flow in a Venturi
- Study on Corrosion Properties of Welded Ferritic-Martensitic Steels in Liquid Lead-Bismuth at 600°C
- Cavitation Damage in Flowing Liquid Sodium Using Venturi Test Section
- Investigation of Zigzag Rising Bubble Using Spinning Sphere Model(Jets, Wakes and Separated Flows)
- INVESTIGATION OF A ZIGZAG RISING BUBBLE USING A SPINNING SPHERE MODEL(Multiphase Flow)
- Stability of a Magnetically Levitated Diamagnetic Fluid Column
- Study on the Horizontal Oscillation of Magnetically Levitated Liquid Column
- Lead-Bismuth Eutectic Compatibility with Materials in the Concept of Spoliation Target for ADS(International Conferences on Power and Energy System)
- SEPARATION AND WAKE CONTROLS OF A BACK-SPINNING SPHERE BY DIMPLES(Separation and Reattachment)
- Axial oscillation of a magnetically levitated non-magnetic fluid column inside a straight magnetic pipe
- ICONE11-36375 STUDY ON CORROSION PHENOMENA OF STEELS IN PB-BI FLOW
- Study on a Regenerative Fuel Reformer for a Zero-Emission Vehicle System
- A Shock-Tube Study on the Combustion Process of Hydrocarbon Fuels : 2nd Report; Systematic Measurements of Ignition Delays and Presentation of a Reaction Scheme
- Density Wave Instability of Sodium Boiling Two-phase Flow in a Vertical Annulus at Low Pressure
- Corrosion of Steels in Lead-Bismuth Flow
- Heat and Mass Transfer in a Packed Bed Reactor for Calcium Oxide/Carbon Dioxide Chemical Heat Pump
- Thermal Performance Measurement of a Packed Bed Reactor of a Magnesium Oxide/Water Chemical Heat Pump
- Applicability of the ZND Detonation Model to Vapor Explosions
- Metallurgical Analysis of a Tube Ruptured in the Lead Bismuth Corrosion Test Facility
- Broadband active sound control system for air-conditioning duct noise
- Performance Prediction of Active Piezo Fiber Rackets in Terms of Tennis Power
- Feasibility and Performance of Magnetic Theromosyphon with Magnetic Fluid in Non-Gravity Field
- Study on High Speed Lithium Jet For Neutron Source of Boron Neutron Capture Therapy (BNCT)
- Experimental Study on Thermal Interaction of Ethanol Jets in High Temperature Fluorinert
- Effect of Notched Strings on Tennis Racket Spin Performance: Ultrahigh-Speed Video Analysis of Spin Rate, Contact Time, and Post-Impact Ball Velocity
- Density Wave Instability of Sodium Boiling Two-phase Flow in a Vertical Annulus at Low Pressure
- Numerical Analysis of Lead-Bismuth-Water Direct Contact Boiling Heat Transfer
- Durable Reaction Material Development for Magnesium Oxide/Water Chemical Heat Pump
- Utilization of high temperature heat using a calcium oxide/lead oxide/carbon dioxide chemical heat pump.
- Burn-off and Production of CO and CO2 in the Oxidation of Nuclear Reactor-Grade Graphites in a Flow System.