Development of Fe Base Phase Change Materials for High Temperature Using Solid–Solid Transformation
スポンサーリンク
概要
- 論文の詳細を見る
Fe base Phase Change Materials (PCM) for high temperature around 953–1273 K using multiple solid–solid transformations were developed. The amount of latent heat of PCM samples were measured by Differential Scanning Calorimetry. The amount of latent heat of Fe–xCo samples increased with increasing Co addition. The reducing atmosphere was suitable for the samples developed in this work. The durability performance of samples was confirmed by heat treatment experiments. From the viewpoint of heat accumulation/supply ability, cost and durability performance, Fe–Co(–Cr) system alloy is one of the most suitable Phase Change Materials for heat recovery from high temperature exhaust gases.
著者
-
Nishioka Koki
Department of Materials Science and Engineering, Faculty of Engineering, Kyushu University
-
Suura Naoyuki
Department of Materials Process Engineering, Graduate School of Engineering, Kyushu University
-
Ohno Ko-ichiro
Department of Materials Science and Engineering, Faculty of Engineering, Kyushu University
-
Maeda Takayuki
Department of Materials Science and Engineering, Faculty of Engineering, Kyushu University
-
Shimizu Masakata
Department of Materials Science and Engineering, Faculty of Engineering, Kyushu University
関連論文
- Development of Fe Base Phase Change Materials for High Temperature Using Solid–Solid Transformation
- Wetting and Penetration Behavior of Calcium Ferrite Melts to Sintered Hematite
- Behavior of Ironmaking Slag Permeation to Carbonaceous Material Layer
- Effect of Carbon Structure Crystallinity on Initial Stage of Iron Carburization
- Effect of Adding Moisture and Wettability on Granulation of Iron Ore
- Modeling of Dripping Behavior in Particles Packed Bed Filled with Immiscible Fluid
- Effect of Granulation Condition and Property of Raw Material on Strength of Granulated Particle by Tumbling Granulation
- Reaction Behavior during Heating Waste Plastic Materials and Iron Oxide Composites
- Gasification and Reduction Behavior of Plastics and Iron Ore Mixtures by Microwave Heating
- Kinetic Analysis of Spherical Wustite Reduction Transported with CH_4 Gas
- Application of Square-wave Pulse Heat Method to Thermal Properties Measurement of CaO-SiO_2-Al_2O_3 System Fluxes
- A Three-dimensional Mathematical Modelling of Drainage Behavior in Blast Furnace Hearth
- Formation Rate of Calcium Ferrite Melt Focusing on SiO_2 and Al_2O_3 Component
- Dezincing Behavior from Iron and Steelmaking Dusts by Microwave Heating
- Dezincing Behavior from Iron and Steelmaking Dusts by Microwave Heating
- Development of Fe Base Phase Change Materials for High Temperature Using Solid-Solid Transformation
- Effect of FeO in Dripping Slag on Drainage Ability of Slag