Ultrafine Ferrite Grains Produced by Tempering Cold-rolled Martensite in Low Carbon and Microalloyed Steels
スポンサーリンク
概要
- 論文の詳細を見る
Ultrafine ferrite grains as small as a few hundred nano meters were obtained, without severe plastic deformation, by tempering cold-rolled martensite in a low carbon and a microalloyed steel. A multilevel subdivision mechanism responsible for the formation of ultrafine ferrite grains in cold-rolled martensite was discussed. It involves subdividing firstly a prior austenite grain into several martensite packets by phase transformation and then further subdividing the martensite structure into ultrafine cell blocks by plastic deformation. The relatively large misorientation between the ultrafine cell blocks achieved at a moderate strain level in martensite may be attributed to the interaction between the transformation introduced and the deformation introduced dislocations. Ultrafine ferrite grains were developed from the cell blocks during tempering at the temperature range from 500 to 600°C for 60 min. It was also demonstrated that the microalloying precipitates can effectively pin down the movement of dislocations and grain boundaries and thus, can increase the thermo stability of the ultrafine grained microstructure.
論文 | ランダム
- 相互相関型シナジェティックニューラルネットワークに関する研究
- 3 Plaque Stabilization by Angiotensin II Signal Blockade that Inhibits Differentiation and Proliferation of Macrophage Progenitors(New Insight and Therapeutic Strategy for Plaque Stabilization, The 71st Annual Scientific Meeting of the Japanese Circulatio
- 2622 薄肉鋼板被覆高強度PC杭の力学性状について
- セメントミルク注入工法における鉛直載荷試験結果からの周面摩擦力に関する一考察
- Effect of a Ti Interlayer in Evaporated Co-Cr/Fe-Ni Double-Layer Film