Verification of the Design Concept on Nuts in Bolt/Nut Assembly for the Revision of ISO 898-2 and ISO 898-6

スポンサーリンク

概要

• 論文の詳細を見る

• The ISO nuts of styles 1 and 2 specified in ISO 898-2 and ISO 898-6 are designed to prevent the thread stripping failure mode based on the calculation method called the Alexander's theory. However, it have been pointed out that the thread stripping sometimes occurs in over-loaded bolt/nut assemblies of certain sizes and property classes due to the inadequate specifications in the relevant International Standards. This paper treats the design concepts on ISO nuts for the revision of the above ISO Standards, which is now taking place. The simulation program has been reproduced based on the Alexander's theory, and the calculated values were compared with the specified ones. The results clearly show that there are both over-designed specifications and insufficiently designed ones with higher risk of stripping. Therefore, the possible ways to exclude such problems have been considered based on the distribution of the bolt/nut thread strength ratio calculated. Finally, it is shown that that the most practical way is to change the hardness range of nut, and the program to obtain the adequate specifications is proposed with verification.

• 日本機械学会の論文

著者

• SAKAI Hiroaki

  Graduate Student, Nagoya Institute of Technology

• HAGIWARA Masaya

  Nagoya Institute of Technology (Tsukuri College)

• Sakai Hiroki

  Graduate Student, Nagoya Institute of Technology

関連論文

• Liquid Phase Boundaries at 1873K in the Ternary CaO-Al_2O_3-MO_x(MO_x:MgO, ZrO_2) and CaO-SiO_2-MO_x(MO_x:TiO_2, MgO, Al_2O_3) Systems
• 2A2-A07 Robot-on-a-chip : Part1: On-chip Generation of Droplets and Size Control
• Effect of the Residual Stress on the Fatigue Strength of a Bolt in Bolt/Nut Assemblies (Verification of the hypotheses using an axi-symmetric bolt model) : (Verification of the hypotheses using an axi-symmetric bolt model)
• Development of a New Testing Machine for Torque/Clamp Force Testing for Threaded Fasteners in Accordance with ISO 16047 -Characteristics of a Load/Torque Cell System Using Piezoelectric Force Sensors-:-Characteristics of a Load/Torque Cell System Using P
• Verification of the Design Concept on Nuts in Bolt/Nut Assembly for the Revision of ISO 898-2 and ISO 898-6

スポンサーリンク