Structural Design of 80-Story RC High-Rise Building Using 200Mpa Ultra-High-Strength Concrete
スポンサーリンク
概要
- 論文の詳細を見る
This paper presents the design of an 80-story reinforced concrete (RC) high-rise building using 200 MPa ultra-high-strength concrete. Static nonlinear push over analyses, Level-1 and Level-2 nonlinear earthquake response analyses and nonlinear wind response analyses were carried out. Based on the three-dimensional static nonlinear analyses of the building subjected to design earthquake loading in two principal directions, the obtained maximum axial load ratio for the first story columns of 200 MPa compressive strength concrete were 0.53 and 0.48, respectively, at the ultimate limit state, which meets the design criterion based on the allowable compressive stress of concrete. The maximum story drift angle obtained under the synthetic wave motion at the construction site was smaller than the design limiting value of 1/100. While yield hinges developed only in some of the short beams, no yield hinge in columns was observed. The maximum ductility of 1.28 obtained in the beams is lower than the design limiting value of 4.0. The maximum story shear force for the level-2 wind load was almost half that of the level-2 earthquake load when using the lumped-mass model. The analyses confirmed that the use of 200 MPa concrete enables structural designers to provide the member sections with adequate sizes comparable to that of ordinary high-rise RC buildings. The analytical results showed that the performance of the building satisfies the design criteria for serviceability limits, design limits and ultimate limits.
- 公益社団法人 日本コンクリート工学会の論文
公益社団法人 日本コンクリート工学会 | 論文
- セメントの水和反応と硬化組織
- 城郭の石垣
- 鉄筋コンクリート研究小史
- 構成要素論から見たセメント工学
- Experimental Study on Bond-Strengthening Hooks for RC Beams