Heat Transfer in Minichannel Gaseous Cooling
スポンサーリンク
概要
- 論文の詳細を見る
Heat transfer was investigated experimentally for high pressure ratio air flow in square minichannels, which were machined on the oxygen free copper block. The sizes of the channels were 0.3, 0.6, 1.0 and 2.0mm, and the length were 10, 20, 50 and 100mm. The pressure ratio was changed widely up to the flow choked at the exit. It was found that the heat transfer coefficient was about 7.3 times greater than fully developed turbulent pipe flow. Experimental result showed that 75 percent of the total heat was transfered in 10 percent inlet portion of the channel.
- 一般社団法人 日本機械学会の論文
著者
-
INOUE Masahiro
Sasebo National College of Technology
-
FURUKAWA Masato
Kyushu University
-
HARA Kazuo
Kyushu University
関連論文
- Numerical Analysis of Tip Leakage Flow Field in a Transonic Axial Compressor Rotor
- Development of a High-Performance Wind Turbine Equipped with a Brimmed Diffuser Shroud
- Unsteady Flow Behavior Due to Breakdown of Tip Leakage Vortex Visualized by Identifying the Vortex Cores
- Numerical Methods for the Compressible Navier-Stokes Equations Using an Explicit Time-Marching Technique (Comparison Between the Four Stage Runge-Kutta and Two Stage Rational Runge-Kutta Schemes) : Series B : Fluids Engineering, Heat Transfer, Combustion,
- Development of End-Bent/Swept Blade for Multistage Axial Compressors(Dissertation Prize,GTSJ Prize)
- Development of End-Bent/Swept Blade for Multistage Axial Compressors
- Studies on the Three-dimensional Flow Field in a Turbine Scroll (1st Report, Measurements of Secondary Flows) : Series B : Fluids Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- Heat Transfer in Minichannel Gaseous Cooling