Fatigue Crack Propagation Behavior Bent from Precrack under Mixed-Mode Conditions - Noting the Crack-Surface Contact due to a Compressive Residual Stress along a Precrack -
スポンサーリンク
概要
- 論文の詳細を見る
A testing for bent fatigue crack propagation under mixed-mode conditions was carried out using fatigue and annealed slant precracks with different slant angles, β ,defined as the angle between loading and precrack directions in a rectangular plate. As a result, bent fatigue crack from the fatigue precrack with β =45deg. propagated under mixed-mode conditions with mode II stress intensity factor (K(II))(est) evaluated from the discontinuous displacement measured along the crack. On the other hand, bent fatigue crack from the fatigue precrack with β =60deg. and from the annealed precracks with both slant angles of β =60deg. and β =45deg. propagated under the mode I behavior. This was because the compressive residual stress near the fatigue precrack caused contact to each other between the upper and the lower surfaces of the precrack with the smaller slant angle β . Furthermore, the fatigue crack propagation rates indicated almost the same relationship for all the data, using the mixed-mode effective stress intensity factor (K(M))(est), calculated from the discontinuous displacement measured along the bent fatigue crack.
- Faculty of Engineering, Okayama Universityの論文
- 2006-01-00
Faculty of Engineering, Okayama University | 論文
- Numerical Simulation of Acoustic Waves in a Two-Dimensional Phononic Crystal: Negative Refraction
- Information Transfer and Entanglement Creation by Spin Chains: Effects of Noise and Asymmetry
- Vibrational Properties of Si Crystal with Vacancy : A Tight-Binding Study
- Stochastic-Dierence-Equation Method for Long Time-scaleMolecular Dynamics Simulations
- Melting of Spherical Yukawa Clusters Analyzed by Monte CarloSimulation