Thickness and surface structure of a ceramic layer created on three indirect resin composites with aerosol deposition.
スポンサーリンク
概要
- 論文の詳細を見る
PURPOSE: Aerosol deposition is a technology for coating ceramics with impact consolidation at room temperature. The aim of the present study was to investigate the thickness and the microstructure of the aluminium oxide layer on different three dental resin composite materials created by means of aerosol deposition. METHODS: Disk-shaped specimens were fabricated with three resin composites (Estenia C&B, Targis, and Gradia). The specimens were ground flat, and then subjected to aerosol deposition using aluminium oxide submicron particles without inducing a localized temperature rise. The average thickness (AVH) and maximum thickness (Hmax) of the aluminium oxide layer deposited on the resin composite material were measured using a profilometer. Data were analyzed by ANOVA and post hoc Tukey compromise test at alpha=0.05. The specimen surfaces were also observed using a scanning electron microscope. RESULTS: The aluminium oxide layer formed on Estenia C&B (AVH 8.1mum, Hmax 9.1mum) and Targis (AVH 7.7mum, Hmax 8.9mum) were significantly thicker than that on Gradia (AVH 4.2mum, Hmax 5.4mum). The micrograph showed that the aluminium oxide layer on Estenia C&B was similar to that on Targis. However, the aerosol deposition area of Gradia was seen relatively rough and partly caved. CONCLUSIONS: The type of resin composite affected the microstructure of the deposited aluminium oxide layer. The highly filled light- and heat-cured resin composites are advantageous as a target material rather than the lower filled light-cured resin composite.
論文 | ランダム
- 目で見る学習 話しあってみよう! なぜ、非正規雇用の仲間の待遇改善が必要か? (特集 有期雇用の抜本規制、パート労働法の改正を)
- 科学的社会主義の古典入門講座 『フォイエルバッハ論』のすゝめ(新連載・第1回)古典のすゝめ。『フォイエルバッハ論』のすゝめ。
- ひろげよう、総学習運動! 安保が分かれば、世界が見える!(新連載・第1回)なぜ、いま日米安保か
- 最賃時間額は、少なくとも1000円以上に! : 最賃裁判をたたかう神奈川の仲間たち
- 二〇一二春闘で、中小労働者は春闘再構築への礎となる闘いを!