D13 Development of Cutting Force Measurement Technique for Milling Process with Small Diameter End Mill(Monitoring of machining process)

スポンサーリンク

概要

• 論文の詳細を見る

• Milling is one of the most important metal cutting processes. If we measure the cutting force, we can make cutting process optimum, prevent tool breakage, and improve efficiency of process. However in the case of using an end mill with small diameter, it is very difficult to identify whether cutting process is good or not. In this paper, we proposed the cutting force measurement technique by using image processing. In the technique, we captured a image of the end mill during cutting process, determined deflection of the tool and then estimated cutting force. Finally, we can estimate small cutting force with high accuracy.

• 一般社団法人日本機械学会の論文
• 2009-12-01

著者

• Kawai Tadao

  Department Of Mechanical & Physical Engineering Osaka City University

• NARUKAWA Kanae

  Department of Mechanical & Physical Engineering, Osaka City University

• Narukawa Kanae

  Department Of Mechanical & Physical Engineering Osaka City University

関連論文

• Effects of Tripping Wires on Heat Transfer from a Circular Cylinder in Cross Flow : 1st Report, The Pressure Distribution around the Cylinder and the Drag Coefficient
• D13 Development of Cutting Force Measurement Technique for Milling Process with Small Diameter End Mill(Monitoring of machining process)

スポンサーリンク