B17 Study on Turning of Micro Shaft : Control of Thrust Force Considering Vickers Hardness of Workpiece(Advanced machining technology)
スポンサーリンク
概要
- 論文の詳細を見る
The method used for turning micro shafts less than 1mm in diameter has been suggested, and clarified to establish the technical system. A linear relationship between thrust force and depth of cut, under a controlled condition of approach angle was also confirmed in experiments. The empirical equation was obtained for estimation of thrust force. It is well known that the cutting force increases as workpiece hardness increases. The relationship between thrust force and Vickers hardness is investigated in this study. On basis of experimental results, it could be confirmed that the linear relationships are established between the each coefficient of the empirical equation suggested here and Vickers hardness of workpiece.
- 一般社団法人日本機械学会の論文
- 2009-12-01
著者
-
Lee Hwa-soo
Department Of Mechanical Engineering College Of Science & Technology Nihon University
-
Miura Kohichi
Department Of Mechanical Engineering College Of Science & Technology Nihon University
-
Miura Kohichi
Department Of Mechanical Engineering Collage Of Science And Technology Nihon University
-
Yamada Takazo
Department Of Mechanical Engineering College Of Science & Technology Nihon University
関連論文
- W-02 Next step for tighter relationship of affiliated universities Example of College of Science and Technology, Nihon University(International Session-I)
- Quantitative estimation of fracture speeds of grinding wheels due to the centrifugal force by means of the grinding wheel model(Grinding technology)
- B17 Study on Turning of Micro Shaft : Control of Thrust Force Considering Vickers Hardness of Workpiece(Advanced machining technology)
- EXPRESSION OF ANGULAR ROTATION OF A MULTIBODY SYSTEM : Application to a rotational expression of a flexible body