Development of in-Process Tool Wear Monitoring System for CNC Turning
スポンサーリンク
概要
- 論文の詳細を見る
The aim of this research is to develop an in-process tool wear monitoring system for CNC turning machine. The exponential decay function is employed to represent the relation between the nominal specific cutting resistance and feed rate. An index value a in the exponential decay function is defined to estimate the flank wear, which is equivalent to the rate of increase in the nominal specific cutting resistance at zero feed rate as compared to that at infinite feed rate. In order to obtain the characteristic value a, the additional cutting cycles is proposed here to alter the feed rate deliberately during the normal cutting cycle to measure the cutting forces and identify the rate of increase in the nominal specific cutting resistance at smaller feed rates. Series of cutting tests were carried out to estimate the flank wear, and it is proved that the index mentioned above can be a good measure of tool wear, even though the depths of cut, the cutting speeds and the cutting tools, as well as the work materials are different.
- 一般社団法人日本機械学会の論文
- 2004-09-15
著者
-
Moriwaki Toshimichi
Department Of Mechanical Engineering Kobe University
-
Moriwaki Toshimichi
Faculty Of Engineering Kobe University
-
TANGJITSITCHAROEN Somkiat
Graduate School of Science and Technology, Kobe University
-
SHIBASAKA Toshiroh
Graduate School of Science and Technology, Kobe University
-
Tangjitsitcharoen Somkiat
Graduate School Of Science And Technology Kobe University
関連論文
- Development of 6 Axis Force Sensor for Javelin Throw
- Development of in-process chip-breaking detection system in turning
- 314 旋削工具のインプロセス・モニタリングシステムの開発
- Study on Near Dry Machining of Aluminum Alloys(Advanced Manufacturing Technology [I])
- Study on Near Dry Machining of Aluminum Alloys(Advanced machining technology)
- Study of Ultraprecision Orthogonal Microdiamond Cutting of Single-Crystal Copper
- P-9 Continuous Measurement of Tympanic Temperature using Infrared Thermometer with Optical Fiber (Proceedings of the 38th Meeting of Japan Society of Physiological Anthropology)
- Decentralized Job Shop Scheduling by Recursive Propagation Method
- Development of Sequential Optimization Method for CNC Turning Based on In-Process Tool Wear Monitoring
- Development of in-Process Tool Wear Monitoring System for CNC Turning
- Experimental Analysis of Ultraprecision Machining