A Study on Chatter Prediction in High-Speed End Milling Process by Fuzzy Neural Network
スポンサーリンク
概要
- 論文の詳細を見る
The purpose of this study is to introduce a new approach for predicting chatter in high-speed end milling by using a fuzzy neural network. First, a milling experimental setup is built and a set of valuable experimental data is acquired under different tool wear states and carefully selected cutting parameters. Second, the experimental system is simplified into a fuzzy neural network model that is trained in the experimental data. Third, some simulation results are obtained on the basis of the trained model. Finally, the calculated results are compared with the experimental ones in order to check the effectiveness of the method described.
- 一般社団法人日本機械学会の論文
- 2001-09-15
著者
-
Yoshimura Toshio
University Of Tokushima Faculty Of Engineering Department Of Mechanical Engineering
-
HINO Junichi
University of Tokushima, Faculty of Engineering, Department of Mechanical Engineering
-
SU Chuanxin
University of Tokushima, Faculty of Engineering, Department of Mechanical Engineering
-
Hino Junichi
University Of Tokushima Faculty Of Engineering Department Of Mechanical Engineering
-
Su Chuanxin
University Of Tokushima Faculty Of Engineering Department Of Mechanical Engineering