Cutting Force Estimation Systems Based on AC Spindle Drive

スポンサーリンク

概要

• 論文の詳細を見る

• Monitoring of the cutting force signals in turning process has been well emphasized for unmanned machining. Although the cutting force can be directly measured by a tool dynamometer, direct sensing in factory environment is not feasible because of high cost and limitations in setup. In this paper two indirect cutting force estimation systems are developed based on the measured output power and on the calculated input power signals, respectively. These estimation systems consider the cutting force as a disturbance input to the spindle drive and estimate the cutting force based on the inverse dynamic model. The inverse dynamic model represents the dynamic relation between the cutting force, the motor torque and the motor power. The proposed estimation systems are realized on a CNC lathe and their estimation performance is evaluated experimentally.

• 一般社団法人日本機械学会の論文
• 2000-03-15

著者

• HUH Kunsoo

  School of Mechanical Engnieering, Hanyang University

• Lee Kang-kyu

  Research Laboratory

• Huh Kunsoo

  School Of Mechanical Engineering Hanyang University

関連論文

• Unmanned Turning Force Control Based on the Spindle Drive Characteristics
• Optimal Task Sequence Planning for High Speed Robotic Assembly Using Simulated Annealing
• Cutting Force Estimation Systems Based on AC Spindle Drive
• F-5-2-2 Development of a Multi-body Dynamics Simulation Tool for Tracked Vehicles, Part II : Application to Track Tension Controller Design
• T-2-4-1 Design of the Well-Conditioned Observer Using the Non-Normality Measure
• Development of a Multi-body Dynamics Simulation Tool for Tracked Vehicles : Part II, Application to Track Tension Controller Design ( Multibody Dynamics)

スポンサーリンク