Carbon Microfibers Grown on Graphite Electrode During Fullerene Generation Using Composite Graphite Rods
スポンサーリンク
概要
- 論文の詳細を見る
Using carbon/metal composite electrodes, silver-colored carbon deposits were obtained on the top edges of negative electrodes during electric arc vaporization for fullerene generation. Needle-shaped, rod-shaped, and winding carbon fibers 20-30 μm in length and 3-4 μm in diameter were observed on the surface of the deposits, using a scanning electron microscope (SEM). The results of energy-dispersive X-ray (EDX) microanalysis on the fibers showed that metal carbides exist at the top portions of these fibers. It was suggested that the growth of such fibers was induced by the catalytic activity of small clusters of metal carbides which act as seeds. The structures of the fibers were discussed based on these experimental results.
- 社団法人応用物理学会の論文
- 1994-07-15
著者
-
Takahashi Nobuaki
Tokyo Electron Limited.
-
ATA Masafumi
Sony Corporation Research Center
-
Imoto H
R & D Division Sony Corporation Battery Group
-
Matsuzawa N
Assoc. Super‐advanced Electronics Technol. Kanagawa Pref. Jpn
-
Matsuzawa Nobuyuki
Sony Corp. Atsugi Jpn
-
Takahashi N
Department Of Materials Science And Engineering & Frontier Research Center Graduate School Of En
-
KIJIMA Yasunori
Sony Corporation Research Center
-
IMOTO Hiroshi
R & D Division, Sony Corporation Battery Group
-
TAKAHASHI Noboru
Sony Corporation Research Center
-
Kijima Y
Sony Corp. Yokohama Jpn
関連論文
- Theoretical Calculation of Photoabsorption of Various Polymers in an Extreme Ultraviolet Region
- Theoretical Estimation of Absorption Coefficients of Various Polymers at 13 nm
- Dissolution Rate Analysis of ArF Resists Based on the Percolation Model
- Sob-0.1-μm-Pattern Fabrication Using a 193-nm Top Surface Imaging (TSI) Process
- Modulation Frequency Characteristics of Erbium-Doped Fiber Amplifier
- Dependence of Frequency and Pressure on Electron Energy Distribution Functionsin Low Pressure Plasma
- Theoretical Calculations of Sensitivity of Deprotection Reactions for Acrylic Polymers for 193nm Lithography II : Protection Groups Containing an Adamantyl Unit
- Bilayer Resist Process for ArF Lithography
- Silylation for Carboxylic Acids
- Theoretical and Experimental Study on the Silylation of Alcohol Units in ArF Lithography Resists
- Study of High Photo-speed Top Surface Imaging Process Using Chemically Amplified Resist
- Diffusion Kinetic of Vapor-phase Silylation Process for ArF Lithography
- Estimation of Reactivity of Isocyanate Groups by Calculation and Magnetochemical Measurement
- Polymer-C_ Composite with Ferromagnetism
- Thermal Behavior of Large-Diameter Silicon Wafers during High-Temperature Rapid Thermal Processing in Single Wafer Furnace
- Design of Single-Wafer Furnace and Its Rapid Thermal Processing Applications
- Single Wafer Furnace and Its Thermal Processing Applications
- Slip-Free Rapid Thermal Processing in Single Wafer Furnace
- Underwater Acoustic Sensor with Fiber Bragg Grating
- Optical Absorption Spectra in CuInS_2 Doped with Fe, Mn and Cr
- Carbon Nanotubes Filled with Gadolinium and Hafnium Carbides
- Spectral Change in Acoustic Pressure and Cavitation Inception
- Carbon Microfibers Grown on Graphite Electrode During Fullerene Generation Using Composite Graphite Rods
- Structures of Carbon Deposits Formed on a Graphite Electrode durirng Fullerene Generation
- Numerical Investigations on Requirements for BARK Materials for Hyper NA Immersion Lithography
- Optical Recording Characteristics of Dye/Polymer Systems
- Effect of the Blending of Binder Polymers on Recording Sensitivity of Dye/Polymer Optical Recording Media
- Estimation of Reactivity of Isocyanate Groups by Calculation and Magnetochemical Measurement