微小水撃角における弾性平板の水面衝撃の研究
スポンサーリンク
概要
- 論文の詳細を見る
It is well known that in the case of the collision between a flat body with very small deadrise angle and a water surface, Wagner's theory is not applicable because of the trapped air effect. This paper describes the study on this trapped air affected region of the water impact problem. In order to investigate the transient situation from the air trapped impact to the Wagner type impact, we have carried out the pressure and the stain measurement at the water impact by dropping an aluminum flat plate of 200 mm breadth and 5 mm thick in the condition of attack angles from zero to 4.0 degrees at intervals of 0.5 degrees. Based on the experimental results, the following conclusions have been derived.(1)Any pressure pattern in time space is clearly identified with the Wagner type or the air trapped type. (2)The impact situation is classified to the following three regions according to the attack angle β. (a)Air trapped type impact region : 0≤β<1° The pressure pattern is the air trapped type all over the impact surface. Flat pressure distribution rises and falls smoothly. (b)Transient region : 1°≤β<3° The Wagner pattern around the keel of the plate and the air trapped pattern at the edge side are observed. The Wagner pressure pattern expands toward the edge with increasing β. Sharp peak pressure is observed. (c)Wagner type impact region : β&gr;3° The pressure pattern is the well-known Wagner type all over the plate. (3)The maximum strain that has the maximum value around β= 0 is moderately depend on e from zero to 4 degrees. The sharp peak pressure hardly affects the strain. (4) The strain calculated statically by loading the measured average pressure is in good agreement with the measured strain. The structural response at impact depends on not only the load but its own structural characteristics. Therefore, further research is needed to evaluate the strength of more complicated structures in practice.
- 社団法人日本船舶海洋工学会の論文
著者
-
角 洋一
横浜国立大学大学院工学研究院
-
岡田 真三
住友重機械・技術開発センター
-
角 洋一
横浜国立大学
-
井上 弘一
横国大
-
向井 広樹
横浜国立大学工学部
-
井上 弘一
(株)ユニシアジェックス
-
向井 広樹
横国大
関連論文
- 洋上風力発電ファームの浮体構造物に対するシステムのリスク評価について
- 28 腐食ピットの確率モデルによる再現腐食表面形状を有する鋼材の引張試験
- OS-11:大型コンテナ船の極厚鋼板溶接継手部の脆性破壊防止について(オーガナイズドセッション報告,春季講演会)
- 11T級大口径ヘリウムフリー超電導マグネットの開発(1)設計
- Illustration of Hull Structures, 恵美洋彦著, A4版, 211頁, 定価8,400円(本会会員の旨記載し,出版社に直接注文の場合,著者特別割引価格8,000円(税・送料込)), 平成18年11月28日発行, 成山堂書店
- き裂伝播シミュレーションに基づく船体構造の疲労き裂管理
- 海事工学の役割と将来についての提言
- 領域合成法による有限要素解析手法の開発 : 平面弾性問題への適用
- 領域合成法に基づく有限要素解析システムの構築 : 2次元弾性問題への適用
- マルチメディアによる船体構造教育システム