R&D on Micro-pyrolyzer for Solid Wastes Using High Temperature Steam and Air(Special Issue on International Conference on Power and Energy System)
スポンサーリンク
概要
- 論文の詳細を見る
An innovative micro-gasification system for solid wastes is proposed in this paper, whose technical feasibility is demonstrated by using rubber chips as a fuel. In this system, a batch-type fixed-bed pyrolyzer combined with a high temperature steam/air reformer is employed. In the present investigation, it is shown that supply of high temperature air into the pyrolyzer significantly increases the heating value of the pyrolysis gas. With the use of high temperature steam/air mixture as an oxidant for reforming, almost complete reforming of the tar components can be done and they are decomposed into CO, H_2 and other hydrocarbon gases with reasonable decrease of the heating value of the reformed gas compared with that of the pyrolysis gas. With packing ceramic balls in the reformer, reforming reactions can be accelerated. The experimental results demonstrate that almost soot and tar free clean reformed gas with the heating value of above 1000 kcal/Nm^3 can be generated from rubber chips.
- 一般社団法人日本機械学会の論文
- 2002-08-15
著者
-
WU Wei
Department of Applied Physics and Chemistry, University of Electro-Communications
-
Yoshikawa Kunio
Department Of Energy Sciences Interdisciplinary Graduate School Of Science And Engineering Tokyo Ins
-
Wu Wei
Department Of Environmental Science And Technology Tokyo Institute Of Technology
-
Yoshikawa Kunio
Department of Environmental Science and Technology, Tokyo Institute of Technology
関連論文
- Reduced Neural Model Predictive Control Strategies for a Class of Chemical Reactors
- E102 CLEAN COMBUSTION OF HEAVY OILS WITH HIGH TEMPERATURE AIR COMBUSTION TECHNOLOGY
- TED-AJ03-615 LOW NO_x COMBUSTION OF PETROLEUM WITH HIGH TEMPERATURE AIR COMBUSTION TECHNOLOGY
- Triboluminescence of 3, 6-Dibromocarbazole
- Analyses of 5' regulatory region polymorphisms in human SLC22A6 (OAT1) and SLC22A8 (OAT3)
- The role of contrast-enhanced ultrasound on the diagnosis of small hepatocellular carcinoma (≦3cm) in patients with cirrhosis
- High Tar Reduction with Porous Particles for Low Temperature Biomass Gasification : Effects of Porous Particles on Tar and Gas Yields during Sawdust Pyrolysis
- E201 High Tar Reduction with Porous-particles for Low Temperature Biomass Gasification : A Consideration of Mechanism of Capacitance Effect
- High performance liquid chromatography analysis of 2-mercaptoethylamine (cysteamine) in biological samples by derivatization with N-(1-pyrenyl) maleimide (NPM) using fluorescence detection
- Liquid chromatography analysis of N-(2-mercaptopropionyl)-glycine in biological samples by ThioGlo^ 3 derivatization
- B106 GASIFICATION PERFORMANCE OF SOLID FUELS USING HIGH TEMPERATURE AIR BLOWN PEBBLE BED GASIFIER
- Cyclin D2 is essential for BCR-mediated proliferation and CD5 B cell development
- A Unified View of Software Agents Interactions(Knowledge Engineering and Robotics)(Knowledge-Based Software Engineering)
- Simultaneous determination of 3-nitro tyrosine, o-, m-, and p-tyrosine in urine samples by liquid chromatography-ultraviolet absorbance detection with pre-column cloud point extraction
- Loss of Anti-Arrhythmic Effect of Vagal Nerve stimulation on Ischemia-Induced Ventricular Tachyarrhythmia in Aged Rats
- 213 Catalytic Reforming of Model Compounds of Pyrolysis Tars(International session)
- Performance of High Temperature Air Combustion Boiler with Low NO_x Emission(Special Issue on International Conference on Power and Energy System)
- Reference-Based Model Predictive Control Scheme for Fed-Batch Bioprocess Optimization
- Nonlinear Ionization Instability of Plasma in Inert Gas Cycle Direct Power Generation
- Output Feedback Control of Uncertain Nonlinear Systems
- A108 PERFORMANCE OF A DUAL-FUELED DIESEL ENGINE DRIVEN BY LOW CALORIFIC GAS
- R&D on Micro-pyrolyzer for Solid Wastes Using High Temperature Steam and Air(Special Issue on International Conference on Power and Energy System)
- Studies on a High Temperature Regenerative Heat Exchanger for Closed Cycle MHD Power Generation : Heat Transfer Analysis for the Combustion Chamber
- B203 PEFORMANCE DEMONSTRATION OF POWER GENERATION FROM SOLID WASTES BY COMBINATION OF PYROLYSIS AND STEAM REFORMING
- A310 Experimental Study on Gasification of Biomass Using a Pebble Bed Slagging Gasifier
- Nonlinear PI/PID Controllers for Free-Radical Polymerization Reactors
- 4-7-4 Combined pyrolysis and catalytic reforming of waste plastic for the polygeneration of solid, gaseous and liquid fuels
- Reference-Based Model Predictive Control Scheme for Fed-Batch Bioprocess Optimization
- Determination of thiocyl in biological samples by liquid chromatography with ThioGlo^3 derivatization
- Contrasting Dose-Effects of Multi-glycoside of Tripterygium wilfordii HOOK. f. on Glomerular Inflammation and Hepatic Damage in Two Types of Anti-Thy1.1 Glomerulonephritis
- Basic Study on Hydrogen-Rich Gas Production by High Temperature Steam Gasification of Solid Wastes
- Triboluminescence of 3,6-Dibromocarbazole
- Output Regulation of a Class of Nonlinear Systems: Two-Input Control Scheme
- Adaptive Regulation of a Catalytic Continuous Stirred Tank Reactor
- 420 スタティックミキサーを用いたコーン油からのバイオディーゼル製造のためのエステル交換反応の反応速度(新エネルギー(3))
- Polycistronic Expression of Human Platelet Factor 4 with Heparin-Neutralizing Activity in Escherichia coli
- Synthesis and Characterization of Mesoporous SiO_2-CaO-P_2O_5 Bioactive Glass by Sol-Gel Process