酸素および窒素分圧の異なる溶接雰囲気中におけるTIG溶接現象と溶接部の性質(その2) : ジルコニウム合金管の溶接に関する研究(第5報)
スポンサーリンク
概要
- 論文の詳細を見る
The purpose of this study is to investigate the influence of extreamly low levels of oxygen and nitrogen partial pressure, P_<O_2> and P_<N_2> in pressurized TIG welding atmospheres on the welding phenomenon and properties of welds of zirconium alloy tubing. In TIG welding of Zircaloy-2 tubing in welding atmospheres with various P_<O_2> and P_<N_2> in total pressure (P_T) of 0.32 MPa (optionally 0.55 MPa), the arc voltages were measured and the properties of welds (surface discoloration, oxygen and nitrogen contents) were examined. Although definite arc voltage change is not observable at welding in ≦ 12.9 Pa of P_<O_2> and 15.6〜67.2 Pa of P_<O_2+N_2> (P_<O_2>/P_<N_2>=1/4), a tendency of arc voltage drop with increase of P_<N_2> is observed at welding in 13.1〜53.0 Pa of P_<N_2> (P_<O_2>=0.3 Pa). The surface of weld metal and heat affected zone (HAZ) in the atmosphere of 0.3 Pa of P_<O_2> and 1.3 Pa of P_<N_2> remains bright. The surface discoloration is observable slightly on weld metal and HAZ in the atmosphere of 3.4 Pa of P_<O_2>, and with increase of P_<O_2> the initial straw color becomes darker until it gets partially blue. No surface discoloration is observable on weld metals and HAZ in the atmospheres of P_<N_2>≦53.0 Pa with 0.3 Pa of P_<N_2>. The nitrogen content [N] in the weld metal increases linearly with increase of √<P_<N_2>>, and the increasing rate of [N] in inner part of weld metal is lower than that of [N] in outer part. The oxygen content [O] in outer part of weld metal increases linearly with increase of √<P_<O_2>> and shows same relations as [N], although the values of [O] in the weld metals flucutuate more than [N]. The increasing rates of [N] and [O] in the weld metal under P_T =0.32 MPa are lower than that of [N] and [O] in the weld metal under P_T=0.10 MPa which is reported in Report 3.
- 社団法人溶接学会の論文
- 1994-08-05
著者
-
坪井 一
日本ニュクリア・フユエル(株)
-
黒沢 哲
日本ニュクリア・フユエル(株)
-
三嶋 輝昭
日本ニュクリア・フユエル(株)
-
黒沢 哲
日本ニユクリア・フユエル(株)
-
坪井 一
日本ニユクリア・フユエル(株)
-
三嶋 輝昭
日本ニユクリア・フユエル(株)
-
小室 孝次郎
日本ニユクリア・フユエル(株)
関連論文
- 108 有限要素法によるTIG溶接時の温度解析 : BWRジルカロイ燃料棒の溶接技術に関する研究(第4報)
- 337 レーザ溶接部の機械特性並びに耐食特性評価 : BWRジルカロイ燃料棒の溶接技術に関する研究(第3報)
- 111 YAGレーザ溶接部の溶込み特性と検査性 : BWRジルカロイ燃料棒の溶接技術に関する研究(第2報)
- 346 YAGレーザ溶接の雰囲気圧力による溶接特性 : BWRジルカロイ燃料棒の溶接技術に関する研究(第1報)
- 溶接雰囲気とTIG溶接熱影響部の性質(その1) : ジルコニウム合金管の溶接に関する研究(第6報)
- 酸素および窒素分圧の異なる溶接雰囲気中におけるTIG溶接現象と溶接部の性質(その2) : ジルコニウム合金管の溶接に関する研究(第5報)
- TIG溶接による溶接金属の酸素および窒素濃度ディプスプロファイル : ジルコニウム合金管の溶接に関する研究(第4報)
- 酸素および窒素分圧の異なる溶接雰囲気中における溶接現象と溶接部の性質(その1) : ジルコニウム合金管の溶接に関する研究(第3報)
- 時間的に変化する雰囲気中でのTIG溶接現象と溶接部の性質 : ジルコニウム合金管の溶接に関する研究(第2報)
- 封緘溶接時のふくれ現象の解明と防止方法の検討 : ジルコニウム合金管の溶接に関する研究(第1報)
- 119 ジルコニウム合金管の溶接(第8報) : ジルカロイー2管のTIG溶接による熱影響部の性質(その2)
- 118 ジルコニウム合金管の溶接(第7報) : ジルカロイー2管のTIG溶接による溶接雰囲気と溶接部の性質(その5)
- 115 ジルコニウム合金管の溶接(第6報) : ジルカロイ-2管のGTA溶接による熱影響部の性質
- 114 ジルコニウム合金管の溶接(第5報) : ジルカロイ-2管のGTA溶接による溶接雰囲気と溶接部の性質(その4)
- 123 ジルコニウム合金管の溶接(第4報) : ジルカロイ : 2管のGTA溶接による溶接雰囲気と溶接部の性質(その3)
- 122 ジルコニウム合金管の溶接(第3報) : ジルカロイ : 2管のGTA溶接による溶接雰囲気と溶接部の性質(その2)
- 312 ジルコニウム合金管の溶接(第2報) : ジルカロイ : 2管のGTA溶接法による密封溶接
- 311 ジルコニウム合金管の溶接(第1報) : ジルカロイ : 2管のGTA溶接法による溶接雰囲気と溶接部の性質
- BWR 核燃料の溶接技術確立