点溶接機の電流制御の研究

スポンサーリンク

概要

• 論文の詳細を見る

• The fluctuation of the welding current caused by the fluctuation of the source voltage or the secondary impedance variation of the spot welder reflects upon the strength of weld, so from the stand point of heat control it is necessary to control the welding time for improvement of the tensile shear strength. For the above mentioned reason, we used both the ⎰^t_o I^ndt=const. welding time control method and the welding current control method with feed-back loop (n≒2). From the spot welding experiment of mild steel sheet of 1.6mm to 3.2mm thickness, the following results were obtained. (1) In comparison to the welding time and current setting methods without feed-back loop, these control methods could improve the consistency of the tensile shear strength at the decreased welding current to normal welding current, and could increase the reliability of the tensile shear strength. (2) By using both the ⎰^t_o I^2dt=const. welding time control method and the welding current control method with feed-back loop, the tensile shear strength at the welding current about 40 percent less than normal welding current was kept nearly equal to the tensile shear strength of normal welding current specified by R.W.M.A. (3) The setting of the welding time and current in these control methods can be applied to the welding condition specified by R.W.M.A., and no particular difficulty of welding depending on the thickness of mild steel sheet to be welded was observed in the case of above mentioned control methods with feedback loop. (4) In the case of the ⎰^t_o I^2dt=const. welding time control method, it was possible to obtain the tensile shear strengthat the welding condition of A class specified by R.W.M.A. even with a welding current about 30 percent less than normalwelding current. By way of example, the most suitable values of I^2・t replaced ⎰^t_o I^2dt=const. were in the following range plate thickness 1.6mm : (10∿30)×(10)^8 (A^2・cycle) plate thickness 2.3mm : (40∿60)×(10)^8 (A^2・cycle)

• 1969-02-25

著者

• 藤原 紀六

  日立製作所亀戸工場

関連論文

• 抵抗溶接機の電流制御の研究
• 点溶接機の電流制御の研究
• 208 溶接線自動ならい装置の開発(第2報) : 水平すみ肉溶接用非接触ならい装置およびその適用
• (79) 電気圧接機の通電制御機構の研究
• 326 溶接線自動ならい装置の開発(第4報) : 突合せ溶接継手の自動ならい方法
• 207 溶接線自動ならい装置の開発(第1報)非接触式溶接線ならい検出器とその諸特性
• 446 ノーガスアーク溶接の心線送給特性

スポンサーリンク