定速フラツシユ熔接の初期における温度分布について
スポンサーリンク
概要
- 論文の詳細を見る
An useful formula of the temperature distribution during flash and butt welding has been established and the relationship between welding variables have become clear and the optimum welding conditions can be obtained easily. If the heat flow is linear, the material is infinite and the clamp displacement velocity is constant, the following relationships have been acquired by using the theory of thermal conductivity. For the initial current [numerical formula] For the constant velocity flash welding [numerical formula] where q is the heat generation, t is the welding time, h is the heat diffusibility, c is the specific heat, ρ is the density, [numerical formula], X is the distance from the instantaneous flashing surface, x is the distance from the initial contact surface, erf [numerical formula], l is the burn-off distance, υ is the clamp displacement velocity. By comparing these formula with the experimental data, the following conclusions have been obtained. 1) The effective heat generation is proportional to the clamp displacement velocity. 2) Influence of the heat radiation and cooling effect at clamps cannot be neglected 3) There is an upper limit in the temperature distribution and this maximum temperature distribution can be represented by 4) Regarding the flashing surface temperature as a standard, the temperature distribution curves can be obtained according to various clamp displacement velocities and burn-off distances only by calculations without any assumptions.
- 社団法人溶接学会の論文
- 1955-06-01
著者
関連論文
- 電解を応用した加工と処理
- 電解加工法の研究 : 電解液の流れについて
- 電解加工法の研究 : 二枚円板形ノズル内の液の流れ(「電解加工」)
- 電解加工法の研究 : 食塩水の電気化学的特性
- 炭素鋼熔着金属の摩耗(第 1 報) : 顕微鏡による摩耗変質層の観察
- (40) 炭素鋼熔着金属の摩耗(第 1 報) : 顕微鏡による摩耗変質層の観察(昭和 34 年度春季学術講演会講演概要)
- パーライト系熔着鋼の重摩耗
- (27) パーライト系熔着鋼の重麾耗(昭和33年度春季学術講演会講演概要)
- 被覆熔接棒の偏心と被覆の片熔けについて
- 定速フラツシユ熔接の初期における温度分布について
- 点熔接現象の各段階における温度分布について
- フラッシュバット熔接法の研究-1-
- 加工液の性能判定
- 電解加工法(「電解加工」)
- 点熔接における温度分布について : 電極の材質形状を考慮した場合