A Circuit Partitioning Algorithm with Path Delay Constraints for Multi-FPGA Systems (Special Section of Selected Papers from the 9th Karuizawa Workshop on Circuits and Systems)

概要

論文の詳細を見る
In this paper, we extend the circuit partitioning algorithm which we have proposed for multi-FPGA systems and present a new algorithm in which the delay of each critical signal path is within a specified upper bound imposed on it. The core of the presented algorithm is recursive bipartitioning of a circuit. The bipartitioning procedure consists of three stages: 0) detection of critical paths; 1) bipartitioning of a set of primary inputs and outputs; and 2) bipartitioning of a set of logic-blocks. In 0), the algorithm computes the lower bounds of delays for paths with path delay constraints and detects the critical paths based on the difference between the lower and upper bound dynamically in every bipartitioning procedure. The delays of the critical paths are reduced with higher priority. In 1), the algorithm attempts to assign the primary inputs and outputs on each critical path to one chip so that the critical path does not cross between chips. Finally in 2), the algorithm not only decreases the number of crossings between chips but also assigns the logic-blocks on each critical path to one chip by exploiting a network flow technique. The algorithm has been implemented and applied to MCNC PARTITIONING 93 benchmark circuits. The experimental results demonstrate that it resolves almost all path delay constraints with maintaining the maximum number of required I/O blocks per chip small compared with conventional algorithms.
社団法人電子情報通信学会の論文
1997-03-25

A Circuit Partitioning Algorithm with Path Delay Constraints for Multi-FPGA Systems (Special Section of Selected Papers from the 9th Karuizawa Workshop on Circuits and Systems)

スポンサーリンク

概要

著者

関連論文

スポンサーリンク