Characteristics of Spray Injected from Gasoline Injector
スポンサーリンク
概要
- 論文の詳細を見る
This paper discusses the atomization mechanism of a spray injected into a low-pressure field, as the focus of an injection system in a suction manifold of gasoline engines. Pure liquid fuel, which is n-Pentane or n-Hexane, is injected into a quiescent gaseous atmosphere at room temperature and low pressure through a pintle-type gasoline injector. Fuel sprays are observed through photographs with varying back pressure, and the changes in spray characteristics with the back pressure below atmospheric pressure are examined in detail. In particular, in the case of back pressure below the saturated vapor pressure of fuel, the atomization mechanism is discussed from the viewpoint of the flash boiling phenomenon. Spray characteristics can be obtained with the pressure difference between the back pressure and the vapor pressure, corresponding to the intensity of the flash boiling, for various fuels.
- 一般社団法人日本機械学会の論文
- 1994-11-15
著者
-
Senda Jiro
Doshisha University
-
Fujimoto Hajime
Doshisha University Department Of Mechanical Engineering Tanabe
-
Fujimoto Hajime
Doshisha University
-
Senda Jiro
Doshisha University Department Of Mechanical Engineering
-
Yamaguchi Masashi
Mazda Motor Corporation, Technology & Engineering Division
-
Tsukamoto Tokihiro
HORIBA, Ltd., Production & R & D Division
-
Senda Jiro
Doshisha Univ.
-
Tsukamoto Tokihiro
Horiba Ltd. Production & R & D Division
-
Yamaguchi M
Mazda Motor Corporation Technology & Engineering Division
関連論文
- The 2-D Distribution of Vapor and Liquid Phase Fuel in a DI Diesel Engine Using LIEF
- E311 A STUDY ON SOOT BEHAVIOR IN A DI DIESEL COMBUSTION(CI engine combustion/in-cylinder flow)
- I204 A STUDY ON MIXTURE FORMATION PROCESS OF DIESEL FUEL SPRAY IN UNSTEADY AND EVAPORATIVE FIELD(Engine spray)
- Modeling of Diesel Spray Impinging on Flat Wall
- Heat Transfer Characteristics of a Diesel Spray Impinging on a Wall
- Measurement of fuel vapor concentration in flash boiling spray by infrared extinction/scattering technique
- Characteristics of Spray Injected from Gasoline Injector
- Deformation and Breakup Behavior of a Small Droplet Impinging upon a Hot Surface : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- Numerical Analysis of the Deformation Process of a Droplet Impinging upon a Wall
- Round Table Discussion 1 : Ultra Fine Spray
- EM2-1: Exhaust Emission Characteristics of DI Diesel Vehicle by using Real-Time On-Board Measurement System(EM: Exhaust Emission Control and Measurement,General Session Papers)
- MS2-2: Large Eddy Simulation of Diesel Spray Flame using KIVA-LES with Flamelet Model and CIP Scheme(MS: Modeling and Simulation,General Session Papers)