Complete Pole Figure Measurement Using Only Back-Reflection Method with Imaging Plate and Application to Three-Dimensional Analysis of Texture

スポンサーリンク

概要

• 論文の詳細を見る

• Complete pole figure measurement using only a back-reflection method with an imaging plate (IP) was attempted. In our method, complete pole figures were obtained using only the back-reflection method without the use of a transmission method. In particular, the complete pole figure theoretically is obtained when its diffraction angle 2θ is 90°. In the cases of other 2θ values, the complete pole figure is obtained by measuring two incomplete pole figures by the back-reflection method and combining them. Such incomplete pole figures could be simultaneously measured by means of the two-dimensional detection ability of IPs. In addition, the correction of X-ray diffraction intensity to compensate the deviation from the pseudofocusing condition was not needed in our method, unlike Schulz's back-reflection method. Pole density data obtained from our complete pole figures were effectively applied to three-dimensional analysis of the texture of a dual-phase stainless steel sheet. Crystallite orientation distribution functions (ODFs) of each phase were obtained.

• 2001-04-15

著者

• SASAKI Toshihiko

  Department of Materials Science & Engineering, Kanazawa University

• Hirose Hajime

  Center For Cooperative Research Kinjo University

• GOTO Tokimasa

  Department of Management and Information Systems, Aichi Institute of Technology

• Sasaki Toshihiko

  Department Of Materials Science And Engineering Kanazawa University

• Goto Tokimasa

  Department Of Management And Information Systems Aichi Institute Of Technology

• SASAKI Toshihiko

  Department of Material Science and Engineering, Kanazawa University

関連論文

• X-Ray Fractography Using Synchrotron Radiation : Residual Stress Distribution Just beneath Fatigue Fracture Surface
• X-Ray Stress Measurement for -Oriented TiC Films
• Mechanism of corrosion resistance degradation of Cr-plated parts due to heat treatment and its prevention
• X-Ray Evaluation of Pulse-Plated Crack-Free Cr Layer(Materials Evaluation by X-ray and Neutron Diffractions)
• Complete Pole Figure Measurement Using Only Back-Reflection Method with Imaging Plate and Application to Three-Dimensional Analysis of Texture
• Determination of Stress Intensity Factor by Surface Reflected Caustics
• Outcome Independence of Entanglement in One-Way Computation

スポンサーリンク