Simulation of Crack Growth in Thermal Stress Cleaving Using Line Heat Source

スポンサーリンク

概要

• 論文の詳細を見る

• The crack growing behavior in a brittle rectangular plate under transient thermal stress is studied. The transient thermal stress imposed to the rectangle here is that of due to a line heater such as an electric resistance wire which supposed to be perfectly contact to the surface of material. When the heater is placed on the symmetrical axis of the rectangle, the crack propagates just along the heating line, therefore, this situation can be used for dividing a thin rectangular plate into equal two pieces. Contrast to the symmetrical case, on the other hand, the warping of crack propagation path is observed when the heater is placed other than the symmetrical position. The main objective of the present study is to clarify the mechanism of crack path warping in the case of unsymmetrical cleaving through the crack propagation simulation. The simulated and the observed crack path show good agreement with each other and factors which make the crack path warp are understood.

• 一般社団法人日本機械学会の論文
• 1999-10-15

著者

• Imai Yasufumi

  Faculty Of Engineering Nagasaki University

• Motomura Fumitaka

  Faculty Of Engineering Nagasaki University

• SAIMOTO Akihide

  Faculty of Engineering, Nagasaki University

関連論文

• Heat Generation Associated with Rotating Bending Fatigue of a Steel and Deduction of the Fatigue Notch Factor
• Temperature Variation associated with Stable Crack Growth and the Fracture Toughness Value
• Simulation of Crack Growth in Thermal Stress Cleaving Using Line Heat Source

スポンサーリンク