Ultimate Strength of Square Tubes Under Bending Loads
スポンサーリンク
概要
- 論文の詳細を見る
Buckling behavior of square tubes under bending load depends on the direction of the bending moment. This paper considers two directions. The first has an axis which crosses at right angles to a side of a cross section ; the second has an axis which crosses at right angles to a diagonal line of a cross section. Four-point bending tests are conducted at room temperature and at 300 ^C, using square tubes of three thicknesses (2.0, 2.5, and 3.0 mm), but having the same inside width (115 mm, excluding corner radius) and length (4000 mm). Local deformations and ultimate bending loads are measured. An empirical formula of the relationship between buckling wave growth and bending load is obtained by analogy with an equation derived from the results of bending theory for plates with an initial curvature. An empirical formula of the ultimate bending moment is also obtained by applying Karman's effective width theorem for critical loads in plates to square tubes. These formulas are proven to represent the behavior of test and analysis values very well.
- 一般社団法人日本機械学会の論文
- 1993-01-15
著者
-
Hirose Tsutomu
Hitachi Engineering Co. Ltd.
-
Kokubo Kunio
Mechanical Engineering Research Laboratory Hitachi Ltd.
-
Hatsuda Toshio
Mechanical Engineering Research Laboratory Hitachi Ltd.
-
Nagashima Hideaki
Mechanical Engineering Research Laboratory, Hitachi, Ltd.
-
Hirakawa Hiromasa
Hitachi Works, Hitachi, Ltd.
-
Maru Akira
Hitachi Works, Hitachi, Ltd.
-
Konno Mutsuo
Hitachi Engineering Co. Ltd.
-
Maru Akira
Hitachi Works Hitachi Ltd.
-
Nagashima Hideaki
Mechanical Engineering Research Laboratory Hitachi Ltd.
-
Hirakawa H
Hitachi Works Hitachi Ltd.
関連論文
- Low Noise Oscillator Stabilized by Mechanically Modulated Cavity
- Parametric Transducer for Gravitational Radiation Detector
- Strength of a Horizontal Reservoir Supported Partially by Two Saddles in its Cylindrical Part
- Ultimate Strength of Square Tubes Under Bending Loads
- Deformation and Strength of a Horizontal Reservoir Having an Oval Cross Section
- Analysis of Shear Buckling of Cylindrical Shells
- Experimental Study on the Dynamic Buckling of Cylindrical Tanks : Comparison Between Static Buckling and Dynamic Buckling : Solid-Mechanics, Strength of Materials
- Calibration of Vibration Transducers
- Calibration of Gravitational Radiation Antenna by Dynamic Newton Field