H316 NUMERICAL ANALYSIS OF MOISTURE VENTILATION IN A LTHIMUM ION BATTERY MANUFACTURING DRY ROOM(Heat transfer with phase change)
スポンサーリンク
概要
- 論文の詳細を見る
In this paper, the characteristics of moisture ventilation in the lithium ion battery manufacturing dry room are studied numerically using the standard k-ε turbulence model. A steady-state and unsteady behavior of moisture ventilation is analyzed by considering two different cases; i.e., local moisture generation and uniformly distributed moisture generation in the room. In order to evaluate the characteristics of moisture ventilation, three scales of ventilation efficiency and characteristic ventilation time are presented from numerical results. It was shown that moisture diffusion was dependent strongly on the flow field. The characteristics of moisture ventilation were improved by 20% and 40% in terms of 1st scale of ventilation efficiency(SVE1) and 2nd scale of ventilation efficiency(SVE2), respectively, through the modifications of design variables such as the addition of inlets, outlets and partition. A significant improvement in the characteristic ventilation time and moisture exhaust efficiency was also achieved by these modifications.
- 一般社団法人日本機械学会の論文
- 2000-10-01
著者
-
Lim Kwang-ok
School Of Mechanical Engineering Hanyang University
-
Lee Kwan-soo
School Of Mechanical Engineering Hanyang University
-
Ahn Kang-ho
School Of Mechanical Engineering Hanyang University
-
Jung Young-Sick
Graduate School, Department of Mechanical Engineering, Hanyang University
-
Cho Hyoung-Cheol
Graduate School, Department of Mechanical Engineering, Hanyang University
-
Cho Hyoung-cheol
Graduate School Department Of Mechanical Engineering Hanyang University
-
Jung Young-sick
Graduate School Department Of Mechanical Engineering Hanyang University
関連論文
- H316 NUMERICAL ANALYSIS OF MOISTURE VENTILATION IN A LTHIMUM ION BATTERY MANUFACTURING DRY ROOM(Heat transfer with phase change)
- G111 An Experimental Study of the Surface Treatment Effects on the Frosting/Defrosting Behavior of a Fin-tube Heat Exchanger(Heat exchanger fundamentals)
- F110 INVERSE PROBLEM OF DETERMINING THE UNKNOWN WALL HEAT FLUX IN A SINGLE SCREW EXTRUDER(Numerical methods-1)