(1-17) Visualized Analysis of a Pre-Mixed Diesel Combustion Under the High Boosting Engine Condition((NCS-1)Novel Combustion Systems 1-Homogeneous Charge, Premixed Charge Compression Ignition Engines)
スポンサーリンク
概要
- 論文の詳細を見る
The pre-mixed lean diesel combustion (PREDIC) has the possibility of significant reduction of both NOx and smoke emissions. The experimental results of PREDIC without after treatment have shown a NOx emission less than 20 ppm, a level which the conventional diesel engines have never achieved. PREDIC owes to the adoption of electronically controlled common rail fuel injection equipment, which can inject fuel at a scheduled crank angle and provide a good fuel and air mixture by using a pintle swirl nozzle. However, there is a big problem in PREDIC, that is, its output is only a half load of the naturally aspirated conventional engine. In order to obtain higher load, a supercharged and intercooled system has been adopted in a single cylinder engine for PREDIC. PREDIC's load conditions by high boosting are improved in three times higher than in the naturally aspirated (NA) condition. At the same time, the high boost condition causes the deteriorations of both THC and smoke emissions. The emission deterioration of PREDIC under the high boosting condition has been analyzed by using the high-speed photography of laser shadowgraph at bottom view type single cylinder visualized engine. Both the conventional and PREDIC up to the high boosting condition of 3.4 times of NA engine are studied in order to clarify the difference of boosting effects. The processes of mixture formation in both the conventional combustion and the PREDIC have been investigated by observations of combustion photographs. Under the high boosting condition the PREDIC's spray by pintle swirl nozzle does not spread widely and the mixture formation gets worse due to the high cylinder pressure. The PREDIC's mixture formation is more sensitive than the conventional combustion because PREDIC's injection timings are very early and its cylinder pressures vary fifty times from atmospheric pressure when the injection starts. So a better or more improved injection nozzle is needed than the current pintle swirl nozzle and it expects to make an appropriate mixture in several cylinder pressures, which widely vary fifty times from an atmospheric pressure.
- 一般社団法人日本機械学会の論文
- 2001-07-01
著者
-
Aoyagi Yuzo
New A. C. E. Institute Co. Ltd.
-
Aoyagi Yuzo
New Ace Institute Co. Ltd.
-
ASAUMI Yasuo
New ACE Institute Co., Ltd.
-
Kunishima Eiji
New Ace Institute Co. Ltd.
-
HARADA Akira
New ACE Institute, Co., Ltd.
-
Morita Akiyoshi
Japan Automobile Research Institute
-
Seko Toshiyuki
Japan Automobile Research Institute
-
Seko Toshiyuki
Japan Automobile Reaseach Institute Inc.
-
Harada Akira
New Ace Institute Co. Ltd.
関連論文
- Effects of High Boost and High EGR on Super Clean Diesel Engine
- Effect of Biodiesel Fuel on Exhaust Emissions of Modern Diesel Engine
- Effects of Ethanol Addition to PME on Cloud Point and Exhaust Emissions in Diesel Combustion
- High EGR Diesel Combustion and Emission Reduction Study by Single Cylinder Engine(Diesel Engines, Performance and Emissions, Intake Gas Treatment)
- Study on Carbon-Deposit Formation Characteristics and Formation Factors of a Small Diesel Engine Fueled with Rapeseed Methyl Ester
- Diesel Combustion and Emission Using High Boost and High Injection Pressure in a Single Cylinder Engine : Effects of Boost Pressure and Timing Retardation on Thermal Efficiency and Exhaust Emissions(Advanced Combustion Technology in Interna
- Diesel Combustion and Emission Study by Using of High Boost and High Injection Pressure in Single Cylinder Engine : The effects of boost pressure and timing retardation on thermal efficiency and exhaust emissions(Diesel Engines, Performance and Emissions,
- Modeling Ignition and Combustion in Direct Injection Compression Ignition Engines Employing Very Early Injection Timing
- (1-17) Visualized Analysis of a Pre-Mixed Diesel Combustion Under the High Boosting Engine Condition((NCS-1)Novel Combustion Systems 1-Homogeneous Charge, Premixed Charge Compression Ignition Engines)
- The Combustion Process and Exhaust Emission of an Alcohol Diesel Engine with a Dual-Fuel Injection System : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- OS-A2: Diesel Combustion by means of Variable Valve Timing in a Single Cylinder Engine(OS-A High Efficiency and Low Emission Engine by Variable Mechanism,Organized Session Papers)
- OS-A1: Effects of High Boost and High EGR on the Super Clean Diesel Engine : Evaluation using the Transient Test Cycle(OS-A High Efficiency and Low Emission Engine by Variable Mechanism,Organized Session Papers)