Heat Transfer of Slurry Flow with Internal Heat Generation : 1st Report, Fully-Developed Laminar Heat Transfer in a Circular Tube
スポンサーリンク
概要
- 論文の詳細を見る
Recently, the development of a homogeneous reactor which uses an aqueous slurry of uranium oxide or thorium oxide as a reactor fuel or a fertile material has been desired. In this case, the fluid is not a Newtonian fluid but rather a Bingham plastic, and the heat transfer of fluid flow with internal heat generation should be analyzed. This paper presents the analytic solutions of the fully-developed heat transfer of a Bingham plastic with a uniform heat source in a laminar flow through a circular tube with uniform wall heat transfer beyond the entrance region of velocity and temperature. From the results shown in figures, it is clarified that the fluid-temperature distribution, the mixed-mean fluid temperature and Nusselt number are affected heavily both by the ratio of the yield stress to shearing stress at wall and by the wall heat transfer.
- 一般社団法人日本機械学会の論文
著者
関連論文
- Experimental Studies of Burnout under Boiling : 1 st Report, Transient Phenomena to Meltdown
- Experimental Studies of Burnout under Boiling : 2nd Report, On the Effects of Subcooling, Tube Diameter and Air Content
- Heat Transfer from an Inclined Thin Flat Plate by Natural Convection
- Heat Transfer of Slurry Flow with Internal Heat Generation : 3rd Report, Laminar Heat Transfer of Thermal Entrance Region in a Circular Tube for a Pseudo-Plastic Fluid
- On the Local Heat Release Rate in a Combustion Chamber of Gas Turbine
- Heat Transfer of Slurry Flow with Internal Heat Generation : 2nd Report, Laminar Heat Transfer of Thermal Entrance Region in a Circular Tube
- Heat Transfer of Slurry Flow with Internal Heat Generation : 4th Report, Laminar Heat Transfer in Thermal Entrance Region between Parallel Plates for Pseudo-Plastic and Dilatant Fluids
- The Thermo-Aerodynamical Analysis of Combustion Gas Flow : 2nd Report, One Dimensional Theory of Annular Combustion Chamber
- Heat Transfer of Slurry Flow with Internal Heat Generation : 1st Report, Fully-Developed Laminar Heat Transfer in a Circular Tube