On the Theory of the Additional Loss at the Pipe Entrance in Viscous Fluid : 1st Report, On the Influence of Rounded Entrance
スポンサーリンク
概要
- 論文の詳細を見る
When a viscous fluid flows out of a big vessel into a pipe, a part of fluid energy is lost at the entrance region by fluid friction. In the case of a rounded entrance, the author determined the dissipation energy by the method of dividing the region into two parts and assuming the stream functions satisfying the boundary conditions at every region, and showed by numerical calculation how the dissipation energy and the coefficient of a pipe end correction vary with the radius of a rounded entrance. The results are as follows. (1) When the radius of a rounded entrance approaches zero, the value of the dissipation energy approaches that of the strict solution obtained by Weissberg. (2) When its radius increases, the values of the dissipation energy and the coefficient of a pipe and correction increase gradually, and these tendencies are shown distinctly.
- 一般社団法人日本機械学会の論文
著者
関連論文
- Spiral Grooved Bearing Utilizing the Pumping Effect of a Herringbone Journal Bearing : Method of Numerical Calculation and Intluences of Bearing Parameters
- Slow Motion Between Eccentric Rotating Cylinders
- A Useful Numerical Analysis Method for the Dynamic Characteristics of Fluid Film Lubrication : The Case of Incompressible Fluid Lubrication
- Theory of Laminar Flows in Rounded Pipe Entrance : 1st Report, In Very Slow Flows When Mass Force Is Negligible
- Theory of Laminar Flows in Large Rounded Pipe Exit
- Theory on Laminar Flow between Eccentric Straight Pipes
- Theory on Laminar Flow through a Conduit of Arching Cross Section
- On the Theory of the Additional Loss at the Pipe Entrance in Viscous Fluid : 2nd Report, When an Entrance Is Taper Type
- On the Theory of the Additional Loss at the Pipe Entrance in Viscous Fluid : 1st Report, On the Influence of Rounded Entrance