Fundamental Study on Electrohydraulic Forming : III. The Effect of Diameter of Fuse Wire and Circuit Inductance on Pressure Pulse
スポンサーリンク
概要
- 論文の詳細を見る
There have been many studies on electrohydraulic forming in which the deformation characteristics of metallic material are investigated. In most of the studies the wires used as pressure source were very fine. A clear-out account has not been given of the relationship between the dimensions of wires and the initial discharge circuit conditions such as capacitor voltage and circuit inductance, and then for a given stored electrical energy there have been few studies showing what kinds and dimensions of wires to use as effective pressure source. By the reason of F.H. Webb's experimental fact that, when sufficient energy is placed in a wire to vaporize it, the delaying time of boiling is of the order or less than the time required for a sonic wave to traverse the wire at boiling temperature, the longer the delaying time, the higher will be superheating. This paper presents the results of experiments where a capacitor discharge circuit for an electrohydraulic forming machine is used to explode a fine copper wire, diameter of which is 0.14 to 0.40 mm. The best condition for creating a pressure pulse is investigated and discussed.
- 一般社団法人日本機械学会の論文
著者
-
Oyane Moriya
Faculty Of Engineering Kobe University.
-
MASAKI Saizi
Faculty of Industrial Arts, Kyoto Univ. of Industrial Arts and Textile Fibers,
-
Masaki Saizi
Faculty Of Engineering Kyoto University
関連論文
- On the Roughening of Free Surface in Deformation Processes
- The Relationship between Lubrication and Surface Condition of Metals Deformed under Compression : 2nd Report, Experimental Study
- The Relationship between Lubrication and Surface Condition of Metals Deformed under Compression
- Surface Crack in Hydrostatic Extrusion of Brittle Metal
- Dynamic Plastic Deformation of Thin Cylindrical Shells under Internal Impulsive Pressure : 1st Report, Theoretical Analysis
- Dynamic Plastic Deformation of Thin Cylindrical Shells under Internal Impulsive Pressure : 2nd Report, Experimental Investigation
- Development of Laws of Similarity for Electrospark Forming
- Improvement of Formability of Metals in Extrusion by Means of Two-Stage Extrusion
- The Effect of Deformation Speed on Friction and Lubrication in Cold Forging
- Back Pressure Extrusion of Brittle Metals and Metallic Powder
- Criteria of Ductile Fracture Strain
- Fundamental Study on Electrohydraulic Forming
- Fundamental Study on Electrohydraulic Forming : III. The Effect of Diameter of Fuse Wire and Circuit Inductance on Pressure Pulse
- Thoery of Plasticity for Porous Metals
- Fundamental Study of Electrospark Forming : Deformation of Cylindrical Shell and Circular Diaphragm
- Fundamental Study on Electrohydraulic Forming : II. The Effect of Kinds of Fuse Wires and Circuit Inductance on Pressure Pulse
- Cold Back-Pressure Extrusion of Aluminium Powder
- Central Cracking of Extruded Product of Brittle Metal in Hydrostatic Extrusion : 2nd Report, Analysis
- Central Cracking of Extruded Product of Brittle Metal in Hydrostatic Extrusion : 1st Report, Experiment