An Investigation on the Theories of Orthogonal Machining
スポンサーリンク
概要
- 論文の詳細を見る
We have shown a general view of the extant theories on the orthogonal machining in steady state, especially paying attention to the existing limits of the complete solution. It is convenient for estimating these limits to investigate the existing range of the cutting resistance P/Tk related to the shear angle φ applying Hill's theorem to the rigid regions. We investigated the generalized case of the Lee and Shaffer's solution with built-up edge and it is proved that the chip should be rigid contrary to Lee and Shaffer. We attempted some experiments using lead specimens and the obtained relations between φ and λ-α coincided with the theory, but the values of P/Tk were scattered and slightly larger than the theoretical range as a whole. It seemed that φ was affected by the initial condition.
- 一般社団法人日本機械学会の論文
著者
-
Fukuoka Hidekazu
Faculty Of Engineering Osaka Prefectural University
-
Shindo Akio
Faculty Of Engineering Kobe University
-
OTA Tomoya
Faculty of Engineering, Osaka University
-
Ota Tomoya
Faculty Of Engineering Osaka University
関連論文
- On Nonlinear Shell Theories
- Torsional Impact Loading of the Thin-Walled Aluminum Statically Pre-Tensioned
- Reflection and Transmission of Rayleigh Surface Wave at a Surface Crack : Fundamentals
- Texture-Induced Acoustic Anisotropy due to Compressive Deformation : Effects of Strain-Rate and Temperature : Non-Destructive Testing
- Axial Impact of Low Carbon Mild Steel Rod
- A Numerical Approach to Finite Elastic-Plastic Deflections of Circular Plates
- An Investigation on the Theories of Orthogonal Machining
- R-value Acoustoelastic Analysis of Residual Stress in a Seam Welded Plate : Acoustical Measurements and Instrumentation
- Incremental Impact Loading of Plastically Prestressed Aluminum by Combined Tension-Torsion Load
- Slip-Line Field Solution of Shallow Notched Bar Due to Three Point Loading : The Case of Shallow Notch Depth
- Fundamental Frequency of an Isosceles-triangular Plate
- Fundamental Frequencies of Simply Supported but Partially Clamped Square Plates
- Researches on the Strength of Wheel Disc
- General Considerations on the Compression of a Wedge by a Rigid Flat Die : 3rd Report, Solutions in Unsymmetrical Condition and with Rough Die
- Statical Deflection of a Rhomboidal Plate with Clamped Edges Subjected to Uniformly Distributed Pressure