Ultrasonic Fatigue Test of Mild Stee1
スポンサーリンク
概要
- 論文の詳細を見る
In an ultrasonic fatigue test of mild steel, the authors investigated the effects of strain amplitude, mean stress, and pre-strain on the changes of resonant frequency, and found a close relationship between the reduction of resonant frequency due to ultrasonic fatigue and the change of the microscopic structure. "The yield point for the stress of vibration" was defined by a strain amplitude which causes a rapid decrease of resonant frequency. Moreover, from an ultrasonic fatigue test with mean stress, a fatigue limit diagram was made for practical use.
- 一般社団法人日本機械学会の論文
著者
-
Mizuno M
Keio Univ. Yokohama Jpn
-
Kunoh T
Keio Univ. Yokohama Jpn
-
Kuno Takahiko
Faculty Of Engineering Keio University
-
Terao Ken
Faculty Of Science And Technology Keio University
-
Terao Ken
Keio University
-
MIZUNO Masao
Faculty of Engiineering, Keio University
-
ONO Toshio
Faculty of Engineering, keio University
-
Mizuno Masao
Facu1ty Of Engineering Keio University
-
Mizuno Masao
Faculty Of Engiineering Keio University
-
Ono Toshio
Faculty Of Engineering Keio University
関連論文
- Basic Studies of Plastic Working with Vibration : 1st Report, Ultrasonic Vibro-Indentation Hardness of Carbon Steels
- Effect of Clamping Force of Double Nuts on Fatigue Strength of Bolted Connection
- The Surface Tension of Molten Salts Mixtures : (XZ-YZ Systems)
- Ultrasonic Fatigue Test of Mild Stee1
- Heat Treatment by Ultrasonic Heating : 2nd Report : Selection of Heating Position and Tempering
- Heat Treatment by Ultra-sonic Heating : Ultra-sonic Quenching
- BASIC STUDIES OF PLASTIC WORKING WITH VIBRATION : 3rd Report, Ultrasonic Hardness Tester for Multiple Uses and Testing results
- SNotch Effects Under Ultrasonically Vibrating Stress
- Eigen Mode Analysis of Ultrasonic Vibration Systems : Series A : Solid-Mechanics Strength of Materials
- Application of Ultrasonic Cavitation to Metal Working and Surface Treatment of Mild Steel : Solid-Mechanics, Strength of Materials
- Basic Studies of Plastic Working with Vibration : 2nd Report, Basis of Vibro-Indentation Hardness Testing
- Problem of Large Deflection of Coiled Springs
- Distortion of Thin-Walled Open-Cross-Section Members : For the Case of Distortion of Multi-Degree-of-Freedom
- On the Compliance and the Load Factor of Bolted Connections Subjected to Eccentric Loading
- An Analysis of Two Dimensional Large Deformation of Coiled Springs under Comlexed Loads : Series A : Solid-Mechanics Strength of Materials