A Numerical Method for the Limit Analysis of General Shells of Revolution : 2nd Report, Lower Bound Method
スポンサーリンク
概要
- 論文の詳細を見る
A lower bound method of limit analysis of shells of revolution is proposed. The shell is assumed composed of a rigid/perfectly plastic material obeying the Tresca yield condition. The proposed method uses a part of the correct yield surface for shells of revolution, and gives statically admissible solutions. Using this method, the limit loads for two problems are calculated: (1) pressure vessels with rigid circular plates and (2) torispherical pressure vessels. The calculated results are shown in figures and compared with solutions by other methods. Further, experiments are performed with the torispherical pressure vessels, and their results are compared with the calculated results.
- 一般社団法人日本機械学会の論文
著者
-
HAMADA Minoru
Professor, Faculty of Engineering, Osaka University
-
Suzuki Megumu
Professor Department Of Mechanical Engineering Kyoto Institute Of Technology
-
NAKANISHI Hiroshi
Assistant, Department of Mechanical Engineering, Kyoto Institute of Technology
-
Hamada Minoru
Professor Department Of Mechanical Engineering Faculty Of Engineering Osaka University
-
Nakanishi Hiroshi
Assistant Department Of Mechanical Engineering Kyoto Institute Of Technology
関連論文
- Numerical Method for Nonlinear Axisymmetric Bending of Arbitrary Shells of Revolution and Large Deflection Analyses of Corrugated Diaphragm and Bellows
- A Numerical Method for the Limit Analysis of General Shells of Revolution : 2nd Report, Lower Bound Method
- Fundamental Frequencies of Simply Supported but Partially Clamped Square Plates
- Tensile and Compressive Stress Problems for a Rigid Circular Disk in an Infinite Plate