Plastic Behaviour in the Combined Loading along Straight Stress Paths with a Bend : Investigation on the Stress-Strain Relation by an Anisotropic Hardening Plastic Potential
スポンサーリンク
概要
- 論文の詳細を見る
The stress-strain relations of metals in loading along straight stress paths (or straight strain paths) with a bend are investigated experimentally as well as theoretically in the deviatoric stress (or strain) space. Equations of the equi-plastic strain surfaces of various metals after preloadings are given on the basis of the experimental results obtained by subjecting this-walled tubular specimens to combined axial load and torsion. Stress-strain relations for various loading paths are calculated using the equi-plastic strain functions. There is a good agreement between the calculation and the experiment.
- 一般社団法人日本機械学会の論文
著者
-
Shiratori Eiryo
Japan National Railways
-
Ikegami Kozo
The Research Laboratory Of Precision Machinery And Electronics Tokyo Institute Of Technology
-
Ikegami Kozo
Associate Professor The Research Laboratory Of Precision Machinery And Electronics
-
KANEKO Kenji
The Research Laboratory for High Voltage Electron Microscopy, Kyushu University
-
YOSHIDA Fusahito
The Research Laboratory of Precision Machinery and Electronics, Tokyo Institute of Technology
-
MURAKAMI Toshimasa
The Research Laboratory of Precision Machinery and Electronics, Tokyo Institute of Technology
-
Murakami Toshimasa
The Research Laboratory Of Precision Machinery And Electronics Tokyo Institute Of Technology
-
Kaneko Kenji
The Research Laboratory Of Precision Machinery And Electronics Tokyo Institute Of Technology
-
Yoshida Fusahito
Associate The Research Laboratory Of Precision Machinery And Electronics Tokyo Institute Of Technolo
-
Yoshida Fusahito
The Research Laboratory Of Precision Machinery And Electronics Tokyo Institute Of Technology
関連論文
- Cyclic Creep Behavior and Unstable Fracture under True Stress Controlled Cyclic Condition
- Plastic Theory of the Mechanical Ratcheting : Analysis by an Anisotropic Hardening Plastic Potential and Its Comparison with Experimental Results of Brass
- The Yield Condition and Flow Rule of a Metal for The Various Pre-Strain Paths
- Plastic Deformation Behavior of Metal for Complex Loading Paths
- The Stress vactor and the Subsequent Yield Surface in Loading along the Strain Path with a Corner
- Curdlan and Schizophyllan (β-1, 3-Glucans) can Entrap Single-wall Carbon Nanotubes in Their Helical Superstructure
- Constitutive Equation of Cyclic Creep under Increasing Stress Condition
- Plastic Behaviour in the Combined Loading along Straight Stress Paths with a Bend : Investigation on the Stress-Strain Relation by an Anisotropic Hardening Plastic Potential
- The Subsequent Yield Surfaces after Proportional Preloading of the Tresca-type Material
- The Influence of the Bauschinger Effect on the Subsequent Yield Condition
- Rotating Strength of Glass-Carbon Fiber-Reinforced Hybrid Composite Discs
- Rotating Strength of Circumferentially Fiber-Reinforced Composite Discs
- The Subsequent Yield Surfaces after Preloading under Combined Axial Load and Torsion
- Plastic and Creep Deformations of Stainless Steel SUS 304 under Combined Stress States at Room Temperature