動力伝達用平歯車のピッチングについて : 第3報, 潤滑条件とピッチング

概要

論文の詳細を見る
In order to investigate the pitting phenomena, the heat treated gears of 0.35 % carbon steel and the induction hardened pinions of 0.40 % carbon steel were tested with the gear endurance testing machine under the various loads and lubricating conditions. It was observed that, if the loads were beyond a certain value (endurance limit), the pitting grew rapidly with the cycles of load repetition, and the involute errors and dynamic loads of gear teeth increased along with the growth of pitting, and if the loads were below the endurance limit, the pitting appeared to grow only to a certain extent but not any further, and in this case the involute errors and dynamic loads changed little. It is noteworthy that the viscosity of lubricants and the peripheral speeds of the gear remarkably affect the endurance limit.
一般社団法人日本機械学会の論文
1962-06-25