試作燃料噴射率測定機について

概要

論文の詳細を見る
In order to shorten the time for measuring, the new measuring machine for the rate of injection was investigated and manufactured under the following construction instead of the old machine which has single slit. We installed many slits each of which had one oil receiver under it and these positions were situated 1 degree for each 4 degrees on the outer edge of the round plate, which rotates horizontally. At the same time we also obtained a shape of slit for the minimum error of measurement as the angle type. Then the rate of injections meaured by this machine proved that the early aims we was fulfilled, namely it anabled us to shorten the time for measuring, and also to make the erros of measurements small enough.
一般社団法人日本機械学会の論文
1953-08-10