Strength Deterioration and Degradation Mechanism of Glass Chopped Reinforced Plastics in Water Environment
スポンサーリンク
概要
- 論文の詳細を見る
In this paper the effect of water environment on the fracture toughness of glass chopped strand reinforced plastics is discussed. Fracture toughness tests were performed by using compact tension specimens of the composite immersed in distilled water for 10 days to 1.5 years. Acoustic emission signals were detected during the tests. The observation of fracture surfaces by a SEM and the quantitative analysis of dissolution elements from glass fibers by an atomic absorption spectrophotometer were also carried out to clarify the degradation mechanism of the composite. It was found that (1) the fracture toughness obtained by the acoustic emission method decreases as the immersion time is longer ; (2) the decrease of the fracture toughness is caused by the degradation of the bonding interface between glass fibers and the resin matrix and the weakening of glass fibers due to the dissolution of the elements in water.
- 一般社団法人日本機械学会の論文
- 1988-07-15
著者
-
Sekine Hideki
Faculty Of Engineering Tohoku University
-
SHIMOMURA Keiichi
Faculty of Engineering, Tohoku University
-
HAMANA Norio
Tokyo Electric Power Co., Inc.,
-
Shimomura Keiichi
Faculty Of Engineering Tohoku University
-
Hamana Norio
Tokyo Electric Power Co. Inc.
-
Sekine Hideki
Faculty Of Engineering Tohoku Univeristy
-
Sekine Hideki
Faculty of Engineering, Tohoku University
関連論文
- The Law of Similarity on the Fracture Behavior of Continuous Fiber-Reinforced Composite Laminates with Different Ply Thicknesses
- Strength Deterioration and Degradation Mechanism of Glass Chopped Reinforced Plastics in Water Environment
- Postbuckling Behavior of Thin Curved Panels under Axial Compression
- DYNAMIC RESPONSE ANALYSIS OF COMPOSITE LAMINATES WITH MULTIPLE DELAMINATIONS SUBJECT TO IMPACT LOAD
- NUMERICAL ANALYSIS OF IMPACT RESPONSE OF COMPOSITE LAMINATES WITH A DELAMINATION
- Study of Fracture Energy and Fracture Behavior of Short-Fiber-Reinforced SMC Composites on the Basis of Micromechanics