A Measurement of Contact-Pressure Distributions in the Upsetting of Cylindrical Billets
スポンサーリンク
概要
- 論文の詳細を見る
The contact-pressure distribution in upsetting is estimated by measuring the elastic-strain distribution in the loading platen. The strains in the platen are measured by pipe-type strain gages, and are converted into contact pressure by a finite-element analysis. Compensation for the strains due to the friction on the contact surface is possible to some extent. The estimated pressure distributions almost agreed with those measured by the pressure-pin method. The pressure was distributed uniformly over the contact surface in the well-lubricated specimens regardless of the diameter-to height ratio of the specimen, d_0/h_0. Friction hills were observed in the unlubricated specimens with d_0/h_0=4 and 2. A concave pressure distribution was obtained for the specimen with d_0/h_0=1, where the pressure increased from the center to the periphery of the contact surface. The present method can be applied to measure die-pressure distributions in practical metalworking processes.
- 一般社団法人日本機械学会の論文
- 1989-10-15
著者
関連論文
- Improvement of Lubrication in Deep Drawing by Use of a Die with a Slightly Inclined Face : Series C : Vibration, Control Engineering, Engineering for Industry
- A Measurement of Contact-Pressure Distributions in the Upsetting of Cylindrical Billets
- A Study of the Lubrication Mechanisms in Deep Drawing
- Temperature Rise of Foil Strain Gages on Plastics
- The Stress Intensity Factor of a Through Crack in Viscous Lubricating Oil : Solid-Mechanics, Strength of Materials
- Load Position Error Due to Dimensional Error in Beam Type Load Cell : Series C : Vibration, Control Engineering, Engineering for Industry
- The Stress Intensity Factor of a Surface Crack in Viscous Lubricating Oil
- Temperature Variation of Foil Strain Gage by Ambient Air Condition : Series A : Solid-Mechanics, Strength of Materials
- Influence of Friction and Plastic Anisotropy in Cube- and Ring-Compression Test