Formation of a Fluid Film between a Valve Plate and a Cylinder Block of Piston Pumps and Motors : 2nd Report, A Valve Plate with Hydrostatic Pads : Heat Transfer, Combustion, Power,Thermophysical Properties

スポンサーリンク

概要

• 論文の詳細を見る

• A new method for designing the valve plate of axial piston pumps and motors is presented. By adopting a valve plate with hydrostatic pads, fluid film lubrication can be realized on the sliding part between the plate and cylinder block over a wide range of operating conditions. This is in the rare case of a valve plate with conventional hydrodynamic pads. The effects of the main related dimensions and the operating conditions are numerically clarified, and the supporting of the cylinder block is also discussed.

• 一般社団法人日本機械学会の論文

著者

• Yamaguchi Atsushi

  Yokohama National University

関連論文

• Characteristics of a Slipper Bearing for Swash Plate Type Axial Piston Pumps and Motors : 2nd Report, Experiment
• Characteristics of a Slipper Bearing for Swash Plate Type Axial Piston Pumps and Motors : 1st Report, Theoretical Analysis
• Formation of a Fluid Film between a Valve Plate and a Cylinder Block of Piston Pumps and Motors : 2nd Report, A Valve Plate with Hydrostatic Pads : Heat Transfer, Combustion, Power,Thermophysical Properties
• Discrete-Vortex Simulation of a Two-Dimensional Turbulent Impinging Jet : Fluids Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties,

スポンサーリンク