模型試料の圧延による第2相周辺の変形状態の研究
スポンサーリンク
概要
- 論文の詳細を見る
Using the model samples (Fig. 1 and 2) as the two phase alloys which joined by fusion with the various plugs in the annealed square copper bar, the effects of the second phase due to rolling on the deformation of the matrix round of those phases were observed. From the experiments, the following results were summarized ; In the specimens consisting of a softer or harder second phase with the matrix, in general, a softer second phase undergoes greater deformation than the matrix and a harder one tends to deform less than the matrix. The flow line of the matrix round a second phase is disturbed remarkably and degree of the disturbance have reference to the difference of the deformation of the both phases. The region of disturbance of the material are not depend on relative hardness of the both phases and increasing of average percentage reduction of the test-piece, but affected on the size of the each second phase.
- 社団法人日本材料学会の論文
- 1959-05-15
著者
関連論文
- 模型試料の圧延による第2相周辺の変形状態の研究
- 微小ビッカースカタサの測定 : タップへの適用と一般論
- 高圧鋳造材の研究(I)
- 連続鋳造に関する研究(II)
- 24 連續鑄造に關する基礎的研究(日本鐵鋼協會第 48 回講演大會講演大要)
- ニ相構成合金加工の研究 : 加工軟化現象について
- ニ相構成合金の加工の研究
- 連続鋳造に関する研究
- Al合金の鋳造偏折に関する研究-3・4-
- Al合金の鋳造偏析に関する研究-3・4-
- Utilization of Pressure for the Improvement of Metals and alloys
- AI板に現れる2,3の現象
- 圧延用亜鉛合金の研究 : 機械的性質及び軟化速度に及ぼすCrの影響並びに軟化時の二三の現象に就いて