熔鐵の流動性に關する研究 (II)
スポンサーリンク
概要
- 論文の詳細を見る
In the first report (Tetsu-to-Hagne, 39, Sept. 1953, No.9, 948∿953), the relations between the fluidity of molten pig and the temperature, the composition and the degree of deoxidation of pig were observed by the weight which flowed out through the capillary. In this report, the author carried out this research farther with the same apparatus and by the same method. Here Z, L and T were defined as follows Z : the time required to let flow out 0.3kg molten iron through the capillary at the constant pressure. L : the length of the melt which flowed along the mould until solidification. The fluidity of pig was usually measured by this method. T : the temperature of the molten iron. The following results were obtained (1) Z-L relations was shown in one curve, when the samples were taken from the same melt. At the measurement on the samples from the different melts, their relations showed difierent curve at each case. This is due to the fact that Z mainly depended upon the viscosity of pig at the molten state, but L chiefly depended upon the temperature range until solidification from molten state. 2 Z-T relations of the normally used pig were shown in two almost linear relations which were closed at the liquidus point. The curve at the temperature above liquidus point showed an easy grade, but their inclination under the liquidus point became very steep, because the primary crystals appeared in the melt. When 0.7kg Al per 100kg steel was added to the normal molten pig, their Z-T relations became one curve which was steep as same as the Z-T curve under the liquidus point about the normal pig (3) The sand (non-metallic inclusion) in the molten pig which had nearly same composition and yet showed the different fluidity were analized by the HNO_3 method. When the fluidity of pig was high, in general the pig contained high [FeO] within the range of this experiment. (4) The value of Z obtained about 0.3∿0.4% carbone steel at 1540℃ by the same method was nearly 9.2. When 0.2kg Al per 100kg steel was added to these molten steel, Z increased so about 13.0. That is to say, the fluidity of the steel deoxidized sufficiently by Al was smaller than that of the steel which was not deoxidized.
- 社団法人日本鉄鋼協会の論文
- 1953-10-25
著者
関連論文
- 350 高炭素鋼の組織および冷間加工がレラクセーション値に及ぼす作用について(耐熱合金・延性・冷間加工性・線材, 性質, 日本鉄鋼協会第 90 回(秋季)講演大会)
- 22 リムド鋼に關する研究 (I)(日本鐵鋼協會第 47 囘講演大會講演大要)
- 熔鐵の流動性に關する研究 (II)
- 熔鐵の流動性に關する研究 (I)
- 59 熔鐵の粘性(日本鐵鋼協會第 45 回講演大會講演大要)
- 33 熔鐵の流動性の研究(日本鐵鋼協會第 44 回講演大會講演大要)
- 86. 製鋼過程に於ける非金屬介在物の擧動に就て(第 3 報)
- 製鋼過程に於ける非金屬介在物の擧動に就て(第 1 報)