Controllability of Radiative Heat Flux across Mould Flux Films by Cuspidine Grain Size
スポンサーリンク
概要
- 論文の詳細を見る
Apparent reflectivities and transmissivities have been measured as functions of cuspidine grain diameter for mould fluxes having constant degrees of crystallinity. Samples used were two types of synthesised mould flux with the basicity of 1, one of which samples contained 1 mass% of Fe2O3, and the grain diameter was varied in the range 1–3.5 μm. The optical measurements were carried out in the wavelength range 300–2600 nm at room temperature using a spectrophotometer with an integrating sphere. With increasing grain diameter, the apparent reflectivity tended to increase and the apparent transmissivity tended to decrease at higher wavelengths for iron oxide free mould fluxes: it seemed that the apparent reflectivity showed a maximum value and the apparent transmissivity showed a minimum value in the grain diameter range 2–3 μm. In contrast, there was less significant dependence on grain size for mould fluxes containing iron oxides. The total radiative heat flux which may reach the mould from the steel shell has been evaluated using apparent reflectivity and transmissivity data on the basis of an optical process model. It has been found that the total radiative heat flux would be smallest in iron oxide free mould fluxes having the highest apparent reflectivity and the lowest apparent transmissivity at higher wavelengths. Effects of grain size on the radiative heat flux are smaller for mould flux containing iron oxides. Comparison of the total radiative heat flux with the total heat flux including conductive contribution suggests that control of cuspidine grain diameter would lead to reduction of the total heat flux by 7–8% for iron oxide free mould fluxes. In addition, the air gap layer would affect the total heat flux more efficiently where the volume fraction of air in the layer exceeds 85%.
- 2011-09-15
著者
-
Kobayashi Yoshinao
Department Of Gastroenterology And Hepatology Division Of Clinical Medicine And Biomedical Science I
-
Kobayashi Yoshinao
Department Of Metallurgy And Ceramics Science Graduate School Of Science And Engineering Tokyo Insti
-
Susa Masahiro
Department Of Metallurgical Engineering Tokyo Institute Of Technology
-
KUSHIMOTO Atsushi
Department of Metallurgy and Ceramics Science, Tokyo Institute of Technology
-
Endo Rie
Department Of Metallurgy And Ceramics Science Graduate School Of Science And Engineering Tokyo Insti
-
Kushimoto Atsushi
Department Of Metallurgy And Ceramics Science Tokyo Institute Of Technology
関連論文
- Impaired regulation of serum hepcidin during phlebotomy in patients with chronic hepatitis C
- Effect of Nano-Scale Copper Sulfide Precipitation on Mechanical Properties and Microstructure of Rapidly Solidified Steel with Tramp Copper Element
- "In-situ" Observation of the δ/γ Phase Transformation on the Surface of Low Carbon Steel Containing Phosphorus at Various Cooling Rates
- Morphology Control of Copper Sulfide in Strip Casting of Low Carbon Steel
- Mechanisms of Pig-iron Making from Magnetite Ore Pellets Containing Coal at Low Temperature
- The Formation Mechanism of Ca_2Fe_2O_5 from FeO and CaO
- Measurement of Normal Spectral Emissivity of Liquid Copper
- Dubin-Johnson-like black liver with normal bilirubin level
- Influence of phlebotomy on iron-related gene expression levels in the livers of patients with chronic hepatitis C
- Unidentified virus-like particles are detected in plasmas with elevated ALT levels : are they significant of etiological agent(s) of non-B, non-C hepatitis?
- Iron reduction therapy by phlebotomy reduces lipid peroxidation and oxidative stress in patients with chronic hepatitis C
- Iron content and consumption of health foods by patients with chronic hepatitis C
- Lactoferrin inhibits lipid peroxidation in patients with chronic hepatitis C
- Hepatotoxicity associated with Lyophyllum decastes Sing. (Hatakeshimeji)
- Increased expression of multidrug resistance-associated protein 1 (mrp1) in hepatocyte basolateral membrane and renal tubular epithelia after bile duct ligation in rats
- Shift of the Absorption Edge for the Charge Transfer Band in Slags Containing Iron Oxides
- Modulation of organic anion transporting polypeptide 1 and multidrug resistance protein 3 expression in the liver and kidney of Gunn rats
- Nucleation of Acicular Ferrite on Sulfide Inclusion during Rapid Solidification of Low Carbon Steel
- Interaction between Phosphorus Micro-Segregation and Sulfide Precipitation in Rapidly Solidified Steel-Utilization of Impurity Elements in Scrap Steel
- Effect of Phosphorus on Sulfide Precipitation in Strip Casting Low Carbon Steel
- Crystallography and Precipitation Kinetics of Copper Sulfide in Strip Casting Low Carbon Steel
- Precipitation of Copper Sulfides and their Effects on Mechanical Properties in Strip Casting Low Carbon Steel
- Effect of Nano-Scale Copper Sulfide Particles on the Yield Strength and Work Hardening Ability in Strip Casting Low Carbon Steel
- Reduction Kinetics of Iron Oxides in Molten Lunar Soil Simulant by Graphite
- Effects of Both Crystallisation and Iron Oxides on the Radiative Heat Transfer in Mould Fluxes
- Recent advances in bilirubin metabolism research : the molecular mechanism of hepatocyte bilirubin transport and its clinical relevance
- Grain Size Refinements of Mg Alloys (AZ61, AZ91, ZK60) by HDDR Treatment
- Mechanism of Heat Transfer Reduction by Crystallization of Mold Flux for Continuous Casting
- Prediction Equation for Refractive Indices of Alkali and Alkaline Earth Silicate Melts Based upon Local Structure Models
- Ellipsometric Determination of Normal Spectral Emissivities at 632.8nm for Solid Ni-Co Alloys at High Temperature
- Lattice and Radiation Conductivities for Mould Fluxes From the Perspective of Degree of Crystallinity
- Value of the extracellular water ratio for assessment of cirrhotic patients with and without ascites
- Restriction of calorie and iron intake results in reduction of visceral fat and serum alanine aminotransferase and ferritin levels in patients with chronic liver disease
- Determination of Refractive Indices and Linear Coefficients of Thermal Expansion of Silicate Glasses Containing Titanium Oxides
- Electric Resistivity Measurements of Sb2Te3 and Ge2Sb2Te5 Melts Using Four-Terminal Method
- Thermal Conductivity Measurements of Solid Sb2Te3 by Hot-Strip Method
- Controllability of Radiative Heat Flux across Mould Flux Films by Cuspidine Grain Size
- Effect of CaO on Dephosphorising Ability of Deoxidation Slag for Effective Utilisation of Phosphorus in Steel
- A Reversible Change of Reflected Light Intensity between Molten and Solidified Ge–Sb–Te Alloy
- Spectroscopic Ellipsometry Measurements for Liquid and Solid InSb around Its Melting Point
- Formation Kinetics of Iron Oxide in Mould Flux during Continuous Casting
- Determination of Desulphurising Ability for Ca–CaF2 Flux Using Equilibration with Molten Silver at 1673 K in Closed Graphite Crucibles
- Optical Measurement for Solid- and Liquid-Phase Sb
- Optical Measurement for Solid- and Liquid-Phase Sb₂Te₃ around Its Melting Point
- Effects of Valence Control of Iron Ions on Radiative Heat Transfer in Mould Flux
- Effect of CaO on Dephosphorising Ability of Deoxidation Slag for Effective Utilisation of Phosphorus in Steel
- Effect of suppressor of cytokine signaling on hepcidin production in hepatitis C virus replicon cells