Laser Graving of Characters on Ceramic Substrates and Change in Visibility in Corrosive Environments
スポンサーリンク
概要
- 論文の詳細を見る
Laser graving of lines and characters was studied on alumina (Al2O3), zirconia (ZrO2) and silicon carbide (SiC) substrates to apply it to prolonged record conservation media. Graved lines were not clear on alumina and zirconia substrates, whereas on a SiC board, they were clearly identified by optical observation. Characters were graved on SiC substrates, and the stability of their visibility was investigated by thermal and chemical corrosion examinations. In high-temperature corrosion examination of the graved SiC, the visibility of characters decreased after 1 week, but no more changes were subsequently observed. In chemical corrosion examination, the visibility was remarkably degraded in concentrated alkaline solution, but not changed in acid and diluted alkaline solutions.
- 一般社団法人 日本原子力学会の論文
- 2008-04-25
著者
-
GOTO Takashi
Institute for Materials Research, Tohoku University
-
KIMURA Teiichi
Institute for Materials Research, Tohoku University
-
Kimura Teiichi
Institute For Materials Research Tohoku University
-
Goto Takashi
Institute For Material Research Tohoku University
-
Goto Takashi
Institute For Materials Research Tohoku University
-
Ohuchi Jin
Radioactive Waste Management Funding And Research Center
-
TSUJIMOTO Keiichi
Mitsubishi Materials Corporation
関連論文
- Thermoelectricity of CaIrO_3 ceramics prepared by spark plasma sintering
- Thermoelectric Properties of Ca-Ir-O Compounds Prepared by Spark Plasma Sintering
- Preparation of ZrB_2-SiC composites by arc melting and their properties(Global Innovation in Advanced Ceramics)
- Apatite formation behavior on bio-ceramic films prepared by MOCVD
- Precipitation Behavior in a Hanks' Solution on Ca-P-O Films Prepared by Laser CVD
- Calcium Phosphate Films with/without Heat Treatments Fabricated Using RF Magnetron Sputtering
- Hydroxyapatite Formation on Ca-P-O Coating Prepared by MOCVD
- Preparation of Hydroxyapatite and Calcium Phosphate Films by MOCVD
- Hydroxyapatite Formation on CaTiO_3 Film Prepared by Metal-Organic Chemical Vapor Deposition
- Evaluation of Calcium Phosphate Coating Films on Titanium Fabricated Using RF Magnetron Sputtering
- Preparation of Pyrochlore Ca_2Ti_2O_6 by Metal-Organic Chemical Vapor Deposition
- Precipitation Behavior in a Hanks' Solution on Ca-P-O Films Prepared by Laser CVD
- Phase Formation and Solidification Routes Near Mo-Mo_5SiB_2 Eutectic Point in Mo-Si-B System
- Orientation control of α-Al2O3 films prepared by laser chemical vapor deposition using a diode laser
- 3P-179 水素化アモルファスシリコン薄膜上の単純クーマリン・生体膜構成分子複合薄膜(生体膜・人工膜-構造・物性,第47回日本生物物理学会年会)
- 1P-224 リン脂質と色素の複合薄膜のFTIR反射吸収スペクトロスコピーと表面構造観察(生体膜/人工膜・構造物性,第46回日本生物物理学会年会)
- 3P223 水素化アモルファスシリコン薄膜上のレチノイド分子膜への電界効果(生体膜・人工膜-構造・物性,第48回日本生物物理学会年会)
- 3P248 アスパラギン酸含有ゲルとアルギニン含有ゲルの界面におけるイオン伝導の整流特性とa-Si:Hの効果(生体膜・人工膜輸送,第48回日本生物物理学会年会)
- Dielectric properties of (010) oriented polycrystalline Ta_2O_5 substituted BaTi_2O_5 prepared by arc melting(Global Innovation in Advanced Ceramics)
- Effect of Oxygen Partial Pressure on Structure and Dielectric Property of BaTi_2O_5 Films Prepared by Laser Ablation
- Rapid Synthesis of Yttria-Partially-Stabilized Zirconia Films by Metal-Organic Chemical Vapor Deposition
- High Temperature Stability of Anatase Films Prepared by MOCVD
- Thermal Cycle Resistance of Yttria Stabilized Zirconia Coatings Prepared by MO-CVD
- Corrosion Behavior of Ceramics-Coated Hastelloy-XR Alloy in an Ar-SO_2 Atmosphere
- Characterization of Ferroelectric Na_xK_NbO_3 System Films Prepared by Pulsed Laser Deposition
- Optical Properties of Ba_2NaNb_5O_ Film Fabricated by RF Magnetron Sputtering Method
- Preparation of Ba_2NaNb_5O_ Film by RF Magnetron Sputtering Method
- Crystal Growth, Dielectric and Polarization Reversal Properties of Bi_4Ti_3O_ Single Crystal
- Preparation and Dielectric and Electrooptic Properties of Bi_4Ti_3O_ Films by Electron Cyclotron Resonance plasma Sputtering Deposition : Thin Films
- Preparation of Calcium Phosphate Films by Radiofrequency Magnetron Sputtering
- Preparation of BaTiO_3-BaZrO_3 Films by Metal-Organic Chemical Vapor Deposition
- Microstructure and Dielectric Properties of Barium Titanate Film Prepared by MOCVD
- Preparation of Superconducting YBa_2Cu_3O_ Films by ECR Plasma Sputtering
- Characterization of Directionally Solidified B_4C-SiC Composites Prepared by a Floating Zone Method
- Thermoelectric Properties of Hot-pressed Boron Suboxide (B_6O)
- 3P247 アミノ酸を添加した酸性あるいは中性ゲル間界面におけるイオン伝導と水素化アモルファスシリコン膜(生体膜・人工膜輸送,第48回日本生物物理学会年会)
- 3P-178 水素化アモルファスシリコン薄膜上のジミリストイルフォスファチジルコリン・バクテリオロドプシン複合薄膜のIRRAS解析(生体膜・人工膜-構造・物性,第47回日本生物物理学会年会)
- 1P-223 水素化アモルファスシリコン上でアミノ酸を用いて有機色素膜の光吸収特性を制御する方法(生体膜/人工膜・構造物性,第46回日本生物物理学会年会)
- 2P299 Langmuir- Brodgett film of retinoic acid and synthetic AKV peptides of bacteriorhodopsin on hydrogenated amorphous silicon.(40. Membrane structure,Poster Session,Abstract,Meeting Program of EABS & BSJ 2006)
- Corrosion Behavior of Glass Coated Hastelloy-XR in Boiling Sulfuric Acid
- Thermoelectric Properties of B_4C-SiB_n(n=4, 6, 14)In-situ Composites
- Synthesis and Thermoelectric Properties of Boron-rich Silicon Borides
- Epitaxial growth of BaRuO_3 thin films on MgO substrates by laser ablation
- Effect of Ba Substitution on the Microstructure and Electrical Conductivity of Ba_xCa_RuO_3 Thin Films Prepared by Laser Ablation
- Effect of Ba substitution on the microstructure and electrical conductivity of Ba_xSr_RuO_3 thin films prepared by laser ablation(Global Innovation in Advanced Ceramics)
- Microstructure and Electrical Conductivity of CaRuO_3 Thin Films Prepared by Laser Ablation
- Microstructure and Electrical Conductivity of BaRuO_3 Thin Films Prepared by Laser Ablation
- Microstructure and Electrical Conductivity of Epitaxial SrRuO_3 Thin Films Prepared on (001), (110) and (111) SrTiO_3 Substrates by Laser Ablation
- Microstructure and Electrical Conductivity of SrRuO_3 Thin Films Prepared by Laser Ablation
- Optical Properties of Au Nanoparticle Dispersed TiO_2 Films Prepared by Laser Ablation
- Effect of CaO and ZrO_2 co-substitution on dielectric properties of BaTi_2O_5 prepared by arc melting
- Dielectric Properties of Ba_Ca_xTi_2O_5 Prepared by Arc Melting
- Dielectric Property of Polycrystalline ZrO_2 Substituted BaTi_2O_5 Prepared by Arc-Melting
- Dielectric Properties of Poly- and Single-Crystalline Ba_Sr_xTi_2O_5
- Characterization of Directionally Solidified B_4C-TiB_2 Composites Prepared by a Floating Zone Method
- Thermoelectric Properties of Single Crystalline B_4C Prepared by a Floating Zone Method
- High Temperature Transport Property of B- and P-Doped GeSi Single Crystals Prepared by a Czochralski Method
- Preparation of TiC-TiB_2-SiC Ternary Eutectic Composites by Arc-Melting and Their Characterizations
- Preparation of TiB_2-SiC Eutectic Composite by an Arc-Melted Method and Its Characterization
- Thermoelectric Properties of Sr-Ru-O Compounds Prepared by Spark Plasma Sintering
- Preparations of CaRuO_3 Body by Plasma Sintering and Its Thermoelectric Properties
- Densification and microstructure of Al_2O_3-cBN composites prepared by spark plasma sintering(SiAlons and Non-oxides)
- Dielectric Properties of Poly- and Single-Crystalline BaTi_2O_5
- Preparation Conditions of CaTiO_3 Film by Metal-Organic Chemical Vapor Deposition
- Microstructure and Preferred Orientation of Titanium Nitride Films Prepared by Laser CVD
- Microstructures and mechanical properties of TiN-TiB2-Ti5Si3 composites in-situ fabricated by spark plasma sintering
- Laser chemical vapor deposition of TiN film on Ti(C,N)-based cermet substrate using Ti(OiPr)2(dpm)2–NH3 system
- Structural, Electrical and Optical Characterization of SrIrO_3 Thin Films Prepared by Laser-Ablation
- Electrical and Optical Properties of IrO_2 Thin Films Prepared by Laser-ablation
- Preparation of IrO_2 Thin Films by Oxidating Laser-ablated Ir
- Leakage Current Properties of PZT Thin Film Capacitors
- Microstructure Control of Al_2O_3/ZrO_2 Composite by Fibrous Monolithic Process
- Fabrication of Continuously Porous Alumina Body by Fibrous Monolithic and Sintering Process
- Optical Properties of Au/SiO_2 Nano-Composite Films Prepared by Induction-Coil-Coupled Plasma Sputtering
- Preparation of Au/SiO_2 Nano-Composite Multilayers by Helicon Plasma Sputtering and Their Optical Properties
- Acceleration of Deposition Rates in a Chemical Vapor Deposition Process by Laser Irradiation
- Deposition of α-Al2O3 films on Ti(C, N)-based cermet substrate by laser chemical vapor deposition using a diode laser
- Densification, phase transformation and hardness of mullite-cubic BN composites prepared by spark plasma sintering
- Spark plasma sintering of TiN-cubic BN composites
- Fabrication of Hydroxyapatite Film on Ti-29Nb-13Ta-4.6Zr Using a MOCVD Technique
- Laser Graving of Characters on Ceramic Substrates and Change in Visibility in Corrosive Environments
- Phase Relationship in a BaO-Bi_2O_3-TiO_2 System and Electrical Properties of BaTiO_3 with Addition of Bi_4Ti_3O_
- Microstructures and Electrical Properties of Ru-C Nano-Composite Films by PECVD
- Oxidation of Boron Carbide-Silicon Carbide Composite at 1073 to 1773K
- Preparation of Ag-Alloy Top-Electrode for Ferroelectric Pb(Zr, Ti)O_3 Films under Various Atmospheres
- S0201-1-3 Apatite formation in Hanks' solution on Ca_2SiO_4 films prepared by MOCVD
- Dielectric Property of Single Crystalline BaTi_2O_5 Prepared by a Floating Zone Method
- Preparation of BaTi_2O_5 Single Crystal by a Floating Zone Method
- D.C. Polarization of Defect-Perovskite LaTa3O9 (高機能セラミック・デバイス)
- Achitecture of porous hydroxyapatite scaffolds using polymer foam process
- Rapid synthesis of yttria-stabilized zirconia films by laser chemical vapor deposition
- 3A1358 Light induced ion conductive change in gel films which contain amino acids joined on a hydrogenated amorphous silicon film(3A Biol & Artifi memb 4: Transport, Signal transduction,The 49th Annual Meeting of the Biophysical Society of Japan)
- 3A1558 Ammonia sensing by measurement of mass and fluorescence of phospholipid and dye on artificial unit(3A Biol & Artifi memb 4: Transport, Signal transduction,The 49th Annual Meeting of the Biophysical Society of Japan)
- Chemical vapor deposition of iridium, platinum, rhodium and palladium
- Preparation of Al-O-N Films by Electron Cyclotron Resonance Plasma-Assisted Chemical Vapor Deposition
- Effect of Oxygen Gas Addition on Preparation of Iridium and Platinum Films by Metal-Organic Chemical Vapor Deposition
- Surface Structural Comparison of Composite Film of Bacteriorhodopsin and Phosphatidylcholine Fabricated on Amorphous Silicon Dioxide, Crystal Silicon Dioxide, and Hydrogenated Amorphous Silicon
- Ionic Conductivity Enhancement of YSZ Film Induced by Piezoelectric Vibration
- Biomechanical Evaluation of Amorphous Calcium Phosphate Coated TNTZ Implants Prepared Using a Radiofrequency Magnetron Sputtering System
- Preparation of Ni-cBN Composites by Spark Plasma Sintering