Effects of Alloying Elements on Deformation Mode in Ti-V Based β Titanium Alloy System
スポンサーリンク
概要
- 論文の詳細を見る
We have discussed the rule by which the predominant cold deformation modes of metastable β phase are governed depending on their chemical compositions through the examinations of the effects of Sn, Al, and Zr on β-quenched and slightly cold rolled microstructures in a Ti-V based alloy system. It seems in Ti-V binary alloys, that orthorhombic martensitic transformation temperatures Ms and Md are depressed far below room temperature by the athermal ω phase at over about 15%V. Tin and aluminum intrinsically lower these temperatures like vanadium. On the other hand, tin and aluminum simultaneously suppress the athermal ω phase of Ti-16V to first rise Md and even Ms up to above room temperature, respectively. The deformation mode of β phase consequently depends on both the Md temperature and the degree of suppression of the athermal ω phase formation. Alloys having a Md above room temperature undergo stress-induced martensitic transformation. As for alloys having a Md below room temperature, alloys where the athermal ω phase is sufficiently suppressed undergo slip, whereas alloys where it is not so done {332}<113> twinning. Since aluminum strongly suppresses the athermal ω formation, increased Al additions change the deformation mode of Ti-16V from {332}<113> twinning to stress-induced martensitic transformation <I>via</I> a quenched α region or that of Ti-16V-4Sn from stree-induced martensitic transformation to slip. On the other hand, since tin does not suppress it so much as aluminum, increased Sn additions first change the deformation mode of Ti-16V from {332}<113> twinning to stress-induced martensitic transformation but subsequently revive {332}<113> twinning again before slip. The deformation mode of Ti-V-Al-Sn alloys can be interpreted by superposing the effects of V, Al, and Sn. Zirconium also depresses martensitic transformation temperatures and Ti-14V-6Zr undergoes stress-induced martensitic transformation. However, Ti-16V based Zr-added alloys undergo {332}<113> twinning in the wide range of Zr content because the athermal ω phase formation is rarely suppressed by zirconium. This interpretation has solved the discrepancy of the transition of deformation modes of β titanium alloys.
- 社団法人 日本鉄鋼協会の論文
- 1995-07-15
著者
-
Nishimura Takashi
Iron And Steel Research Laboratories Kobe Steel Ltd.
-
OHYAMA Hideto
Titanium Metals Technology Department, Takasago Plant, Kobe Steel, Ltd.
-
Ohyama Hideto
Titanium Metals Technology Department Takasago Plant Kobe Steel Ltd.