Coal-char/Slag Interactions during Pulverised Coal Injection in a Blast Furnace : Reaction Kinetics and Wetting Investigations
スポンサーリンク
概要
- 論文の詳細を見る
The kinetics of reactions taking place in the slag/carbon interfacial region was investigated at 1 500°C for a range of carbonaceous materials, namely synthetic graphite, natural graphite and two coal-chars. Two blast furnace slags, one rich in iron oxide and other rich in silica were used in this study. Slag/carbon reactions were studied in a horizontal tube resistance furnace in argon atmosphere, using the sessile drop approach. The volumes of CO and CO2 evolved were obtained from an analysis of off-gases with the help of a mass spectrometer. These reactivity studies were supplemented with wettability measurements on these systems. With iron oxide rich slag 1, all carbonaceous materials showed non-wetting behaviour without much improvement with time. With silica rich slag 2, natural graphite and coal-chars showed dynamic wetting after some time. Synthetic graphite however continues to remain non-wetting. Reduction of iron oxide was a predominant reaction with slag 1 and reached completion for all carbon substrates. Reduction of silica, main reaction with slag 2, was however partial with considerable amounts of unreduced silica remaining behind even after 1 800 s of contact. Overall reaction rates in the initial stages of contact were quite similar for both graphites whereas both coal-chars showed relatively high reaction rates. These results point towards the important roles played by the chemical composition of slags and carbonaceous materials in reduction reactions.
- 社団法人 日本鉄鋼協会の論文
- 2003-10-15
著者
-
Sahajwalla Veena
School Of Materials Science And Engineering The University Of New South Wales
-
Mehta Arun
School Of Materials Science And Engineering The University Of New South Wales
関連論文
- Investigation of the wetting characteristics of liquid iron on mullite by sessile drop technique
- Chemical Structure of Chars Prepared under Conditions Prevailing in the Blast Furnace PCI Operation
- Characterisation and Corrosion of Laboratory Scale Briquettes of Reduced Iron
- Numerical Analysis of Reactions in a Cupola Melting Furnace
- Influence of Sulfur Content and Temperature on the Carbon Boil and CO Generation in Fe-C-S Drops
- Kinetics of Gas Oxidation of Liquid Fe-C-S Alloys and Carbon Boil Phenomenon
- Degradation Characteristics of Iron Ore Fines of a Wide Size Distribution in Fluidized-bed Reduction
- Role of Ash Impurities in the Depletion of Carbon from Alumina-Graphite Mixtures in to Liquid Iron
- Kinetic Study of Factors Affecting in Situ Reduction of Silica in Carbon-Silica Mixtures for Refractories
- Investigation of in-situ Chemical Reactions of Al_2O_3-SiC-SiO_2-C Refractory and Its Interactions with Slag
- Derivation of Shrinking Core Model for Finite Cylinder
- Dynamic Wetting of Graphite and SiC by Ferrosilicon Alloys and Silicon at 1550℃
- Effect of Carbonisation Conditions on Mineral Matter in Coke
- Kinetic Model for the Uniform Conversion of Self Reducing Iron Oxide and Carbon Briquettes
- Coal-char/Slag Interactions during Pulverised Coal Injection in a Blast Furnace : Reaction Kinetics and Wetting Investigations