Forced Convection Heat Transfer and Temperature Fluctuations of Lithium under Transverse Magnetic Fields
スポンサーリンク
概要
- 論文の詳細を見る
The MHD effects on a heat transfer of liquid lithium flowing in an annular channel were studied, using a newly constructed comparatively large-scale lithium loop. The data on the heat transfer characteristics were arranged in Nu-St diagrams where St=Ha2⁄Re. The diagrams indicate that Nu decreases as St increases as a whole trend. However, singular peaks of Nu were observed at about St=13, corresponding to the singular increments of temperature fluctuations, whereas the peaks occurred at St=1.5 in the previous experiment with a smaller channel. In considering a predominant MHD effect due to conductive wall duct, the current load factor KP for external circuit was taken into account. And Miyazaki number Mi=KPSt, which means the effective electromagnetic interaction, was adopted in substitution for St and the heater pin diameter was taken as the characteristic length in place of the conventional hydraulic equivalent diameter.Thus, an appreciably good agreement was obtained concerning the peaks at Mi=0.13 in the previous and at Mi=0.14 in the present experiments. Generation of vortex series in the singular phenomena was suggested from both the periodicity of temperature fluctuations in their PSD analysis and the proportionality between peak frequency and mean flow velocity, resulting in a 32 mm interval length of series.
- 社団法人 日本原子力学会の論文
- 2001-11-25
著者
-
Inoue Shoji
Osaka University
-
Horoshi Horiike
Osaka University
-
Miyazaki Keiji
Osaka University
-
Yamaoka Nobuo
Osaka University
-
Yamaoka Nobuo
Department Of Nuclear Engineering Graduate School Of Engineering Osaka University
-
Miyazaki Keiji
Department Of Nuclear Engineering Graduate School Of Engineering Osaka University
-
Miyazawa Akira
Department Of Nuclear Engineering Graduate School Of Engineering Osaka University
-
UDA Naoki
Department of Nuclear Engineering, Graduate school of Engineering, Osaka University
-
INOUE Shoji
Department of Electric, Information and Energy Engineering, Graduate school of Engineering, Osaka Un
-
HORIIKE Hiroshi
Department of Electric, Information and Energy Engineering, Graduate school of Engineering, Osaka Un
-
Uda Naoki
Department Of Nuclear Engineering Graduate School Of Engineering Osaka University
関連論文
- ICONE11-36293 ADVANCED INTERMEDIATE HEAT EXCHANGER FOR FBR
- UPPER ATMOSPHERE PHYSICS DATA OBTAINED AT SYOWA STATION IN 1999
- Upper atmosphere physics data obtained at Syowa Station in 1999
- ICONE11-36288 OPTICAL MEASUREMENT OF WAVES ON HIGH-SPEED LITHIUM JET SIMULATING IFMIF TARGET FLOW
- Forced Convection Heat Transfer and Temperature Fluctuations of Lithium under Transverse Magnetic Fields
- Magnetically Guided Free Surface Annular Nak Flow Experiment
- Thinning Improves Surface-Soil Physical Properties of Coniferous Forest Plantations
- Magnetically Guided Free Surface Annular Nak Flow Experiment
- Heat transfer and temperature fluctuation of lithium flowing under transverse magnetic field.
- Temperature fluctuation of sodium in annular flow channel heated by single-pin with blockage.
- Dryout heat flux for core debris bed. III Mixture of intact fuel and particulated clad.:Mixture of Intact Fuel and Particulated Clad
- Film boiling characteristics of potassium droplets on heated plate.
- Thermal interaction of water droplet with molten tin.
- Natural convection heat transfer of liquid lithium under transverse and parallel magnetic fields.
- Cavitation in cylindrical liquid metal shell imploded for axial magnetic flux compression.
- Dryout heat flux for core debris bed. (I) Effects of system pressure and particle size.:Effects of System Pressure and Particle Size
- Pressure Transient and Bubble Growth in Incipient Boiling of Superheated Potassium
- Experimental Studies on Characteristics of Pressure Attenuation and Recovery to Saturation for Decompressive Disturbances in Low Pressurized Water
- Influence of Void and Velocity Variations on Two-Phase Liquid Metal MHD Induction Converter Characteristics
- Influence of Void and Flow Regime on Liquid Metal MHD Induction Generator Using Two-Phase Flow
- Incipient boiling of sodium in an annular channel heated by a single-pin with blockage.
- Dryout heat flux for core debris bed. (II) Effects of particle size mixing and coolant flow.:Effects of Particle Size Mixing and Coolant Flow
- Intensity and Propagation Velocity of Compression Shock Pulses in Low Pressure Steam-Water Medium
- Analysis of Two-Phase Liquid Metal MHD Induction Converter
- Redistribution of gaseous phase of liquid metal two-phase flow in a strong magnetic field.