New Method for Calculating Aggregate Fission Product Decay Heat with Full Use of Macroscopic-Measurement Data

概要

論文の詳細を見る
We propose a new “hybrid” method for calculating the aggregate decay heat from fission product nuclides after a fission burst. The decay heat from a given fissioning system is expressed as a linear combination of macroscopic-measurement data for other fissioning systems with a small residual term. This method is based on the linearity of the decay heat to the fission yield. The coefficients in the linear combination are obtained from fitting the fission yield of the given fissioning system with a linear combination of fission yields of other fissioning systems. To demonstrate usefulness of this method, it is applied to examining the consistency among measured decay heat powers of five fast and three thermal neutron induced fissions. The hybrid-method calculations agree well with the measurements and usual summation calculations at cooling times before 4,000 s, except for a γ component measurement of the 235U thermal fission at about 2,000 s. These results indicate the consistency and reliability of the decay heat evaluation for these systems with the above exception. Furthermore, they also imply usefulness of the present method in predicting the decay heat of other fissioning systems, for which no measurements have been performed so far.
社団法人日本原子力学会の論文
2001-07-25