受賞記念講演 Study on Grain Growth of Fine Grained WC-Co Hardmetal By Numerical Calculation (特集 粉末プロセスのシミュレーション)
スポンサーリンク
概要
- 論文の詳細を見る
This paper reviews our simulation study by numerical calculation based on two-, three- and multi-grain-size models on WC grain growth in fine grained WC-Co hardmetal doped with VC. The study aimed to presume or predict the following: (1) the cause and conditions for the abnormal grain growth which occurs in some cases in the fine grained hardmetal prepared from fine WC powders with mean grain size below about 0.2μm, and (2) how the mean grain size of the hardmetal varies with decreasing mean grain size of the WC starting powder to 0.1 μm or nano-meter size. The calculation results by these three kinds of models suggested the following, respectively: (1) the occurrence of the abnormal grain growth is generally substantial for WC starting powder with bimodal size-distribution and mean grain size below 0.1-0.2μm, and not due to the non-uniform distribution of the grain growth inhibitor, (2) the introduction of middle grains caused the disappearance of small (fine) grains during sintering, leading to abruptly increase of the mean grain size of alloy, and (3) the mean grain size of alloy becomes so large as about 0.3-0.4μm, even when the WC starting powders with nano-size as well as 0.1μm are used.
- 社団法人 粉体粉末冶金協会の論文
- 2000-12-15
著者
-
Matsuoka Naoki
Kobe Steel Ltd.
-
Hayashi Koji
Institute Of Industrial Science The University Of Tokyo
-
松岡 直樹
Kobe Steel,Ltd.
-
林 宏爾
Institute of Industrial Science,the University of Tokyo
関連論文
- Synthesis of New Mono-Carbonitride(W, Mo)(C, N) Powder by Heating W-Mo Alloy+C Mixed Powder in High-Pressure Nitrogen Gas (特集 硬質材料)
- Synthesis of New Mono-Carbonitride Mo(C,N) Powder by Heating Mo+C Mixed Powder in High-Pressure Nitrogen Gas (特集 硬質材料)
- Synthesis New Cabonitride W(C, N)Powder by Heating W+C Mixed Powder in High Pressure Nitrogen Gas
- Effect of Sintering Cooling Rate on V Segregation Amount at WC/Co Interface in VC-doped WC-Co Fine-Grained Hardmetal
- A Consideration on Grain Growth in WC-Co Fine Grained Hardmetal by Numerical Calculation Based on Alloy Model with Three Kinds of Grain Sizes (特集 硬質材料)
- Automation of Measuring Fracture Surface Area and Shortening of Measuring Time for Hard Materials (特集 硬質材料)
- Proposal of Atomic Models for Formation Process of Carbonitride W(C,N) Synthesized by Normal-and High-pressure Methods
- Products Obtained by Heating Cr Powder in CH4+NH3 Mixed Gas of Normal-Pressure (特集 硬質材料)
- Microstructural Development and Properties of New WC-CO Base Hardmetal Prepard From CoxWyCz+C Instead of WC (特集 硬質材料)
- 受賞記念講演 Study on Grain Growth of Fine Grained WC-Co Hardmetal By Numerical Calculation (特集 粉末プロセスのシミュレーション)